The advantage of an electric window regulator is enormous compared to manual systems. However, it has the defect of being much more complex in terms of repairs. In addition, it is not necessarily easy to pinpoint the nature of the fault. With this article we will see how to repair the electric window regulator of a hyundai i30 . But before you start, you have to be sure you know where the problem came from. Indeed, it is sometimes unnecessary to replace the entire window regulator, a simple repair will often suffice. Whether it concerns a false contact, or simply a lack of lubrication. Now that you've identified the source of the problem, let's get to the heart of the matter.
Replacing a window regulator for hyundai i30: how to do it
It takes a long time to change a window regulator. Depending on your expertise on the subject, count approximately three hours to make sure you don't get caught up in time. Whether it is for a Hyundai i30 or another car, this operation is for experienced DIY enthusiasts. So let's look at what to do, step by step. We advise you to take pictures at different times to help you install the new window regulator.
Removing a window regulator on a Hyundai i30
- Remove the entire door trim. From the handle to the mirror cover. This should rather be done with caution using a flat screwdriver. You must ensure that you have access to the window regulator at all points without being disturbed. This step is quite long to perform.
- Disassemble the window regulator seals from your hyundai i30. Again, it is crucial to do this carefully.
- Now that you have access to the window regulator, remove the connectors. You must then remove the motor from the window regulator if it is stuck.
- Remove all the fasteners that hold the window, then remove the window. It is sometimes better to place the window halfway up to be able to carry out this operation. Obviously we will have to be super careful when moving the glass. It is best to put it on a sufficiently thick sheet.
- Disassemble the window regulator as a whole. It is essential to remember its location. You can take a picture of it if it helps you to install the new window regulator. The window regulator is sometimes held in place by screws or rivets, so they must be removed.
The installation of an electric window regulator of a hyundai i30
- Position the new window regulator. Make sure that its position is similar to the damaged window lifter. You should definitely use the fasteners you removed.
- Replace the glass as you removed it. It will sometimes be necessary to move it a little so that it fits properly in its guide.
- Connect the connectors.
- Fit the seals you removed.
- Replace the door trim assembly.
It's good, you now have a new and functional window regulator . So you have to put the ignition on and test it.