The advantage of an electric window regulator is substantial in comparison with manual window regulators. However, it has the disadvantage of being much more complicated in terms of repairs. In addition, it is not necessarily easy to identify precisely the source of the failure. In this article we will see how to repair the electric window regulator of a Hyundai Ix-onic . But before you start, you have to be sure you understand where the malfunction is coming from. Indeed, it is regularly unnecessary to replace the entire window regulator, a simple repair can sometimes work. Whether it concerns an electrical short circuit, or simply a lack of oiling. Now that you are sure of the nature of the concern, let's get back to our topic.
How to replace a Hyundai Ix-onic window regulator
Changing a window regulator is quite time consuming. Depending on your experience in the field, plan approximately three hours to make sure you don't get caught up in time. Whether on a Hyundai Ix-onic or on another vehicle, this manipulation is for experienced DIY enthusiasts. So let's see what to do, step by step. We advise you to take pictures at several stages to help you reassemble the new window regulator.
Removing a window regulator on a Hyundai Ix-onic
- Remove the entire door trim. From the mirror cover to the handle. This should be done very gently using a flat screwdriver. It will be necessary to ensure access to the window regulator at any point without being obstructed. This step is quite long to perform.
- Remove the window regulator seals from your Hyundai Ix-onic. Again, it is essential to do this carefully.
- Now that you have accessed the window regulator, disconnect the connectors. You can then release the window lifter motor if it is stuck.
- Release all the fasteners that hold the window, then remove the window. It is regularly advisable to place the window halfway up to carry out this operation. Of course you have to be very careful when handling the glass. It is advisable to place it on a rather thick sheet.
- Remove the window regulator as a whole. It is essential to remember your position. You can take a picture of it if it helps you to install the new window regulator. The window regulator is regularly held by screws or rivets, it is thus necessary to remove them.
The installation of an electric window regulator of a Hyundai Ix-onic
- Position the new window regulator. Make sure that its position is similar to the damaged window lifter. You will certainly need to use the fasteners you have set aside.
- Replace the glass as you removed it. It will regularly be necessary to move it slightly so that it fits properly in its guide.
- Connect the connectors.
- Replace the seals you removed.
- Replace the entire door trim.
It's good, you now have a new and functional window regulator . So you can switch on and test it.