The interest of an electric window regulator is undeniable in comparison with manual window regulators. On the other hand, it has the disadvantage of being much more complex in terms of repairs. In addition, it is not always easy to identify precisely the nature of the failure. Here we will see how to replace the electric window regulator on a Hyundai Ix20 . But before you start, be sure to understand where the problem is coming from. Indeed, it is from time to time unnecessary to change the entire window regulator, a simple repair will sometimes work. Whether it concerns an electrical short circuit, or quite simply a lack of oiling. Now that you've identified the cause of the malfunction, let's get back to our topic.
How to replace a Hyundai Ix20 window regulator
Changing a window regulator is quite long. Depending on your expertise on the subject, plan approximately three hours to make sure you don't get caught up in the time. Whether for a Hyundai Ix20 or another car, this manipulation is for experienced DIY enthusiasts. So let's see what to do, step by step. We recommend that you take pictures at different times to help you fit the new window regulator.
Removing a window regulator on a Hyundai Ix20
- Remove all of the door trim. From the handle to the retro cover. This manipulation should be done quite gently using a flat screwdriver. It will be necessary to make sure to access the window regulator at all points without being hampered. This step is the longest to perform.
- Remove the window regulator seals from your Hyundai Ix20. Once again, it is essential to do this carefully.
- Now that you have accessed the window regulator, remove the connectors. You must then release the window lifter motor when it is blocked.
- Remove all the fasteners that hold the glass, then remove the glass. It is occasionally preferable to place the window halfway up to carry out this manipulation. Obviously you have to be very careful when moving the glass. It is advisable to place it on a rather thick sheet.
- Remove the window regulator entirely. It is essential to remember your location. You can take a picture of it if it helps you attach the new window regulator. The window regulator is occasionally held by screws or rivets, you must therefore remove them.
The installation of an electric window regulator of a Hyundai Ix20
- Fit the new window regulator. Make sure that its location is similar to the previous window regulator. It will certainly be necessary to use the fixings that you removed.
- Reposition the glass just as you took it out. It will be necessary from time to time to rotate it slightly so that it fits properly in its guide.
- Reconnect the connectors.
- Fit the seals you removed.
- Replace all of the door trim.
That's it, you now have a new and functional window regulator . You must therefore switch on the ignition and test it.