The advantage of an electric window regulator is enormous in comparison with manual mechanisms. Nevertheless, it has the defect of being much more complicated in terms of repairs. Also, it is not always easy to pinpoint the source of the fault. In this article, we will discover how to change the electric window regulator of a Hyundai Ix35 . But before you start, you need to be sure you know where the problem is coming from. Indeed, it is from time to time unnecessary to replace the entire window regulator, a simple repair can often suffice. Whether it concerns an electrical short circuit, or simply a lack of oil. Now that you are sure of the cause of the problem, let's get to the heart of the matter.change-window-lift-Hyundai-Ix35

How to replace a Hyundai Ix35 window regulator

The replacement of a window regulator is quite long. Depending on your experience in the field, count approximately three hours to make sure you have the time you need. Whether on a Hyundai Ix35 or another vehicle, this manipulation is for experienced DIY enthusiasts. So let's look at how to do it, step by step. It is advisable to take photos at several stages to help you reassemble the new window regulator.

Removing a window regulator on a Hyundai Ix35

  • Remove the entire door trim. From the mirror cover to the handle. This should be done very gently using a flat screwdriver. It will be necessary to ensure access to the window regulator at any point without being disturbed. This step is quite long to perform.
  • Remove the window regulator seals from your Hyundai Ix35. Again, it's important to be careful.
  • Now that you have accessed the window regulator, disconnect the connectors. You must then remove the motor from the window regulator when it is stuck.
  • Remove all the clips that hold the glass, then remove the glass. It is from time to time more advisable to position the window halfway up to be able to carry out this operation. Obviously you have to be very careful when moving the glass. It is best to put it on a rather thick sheet.
  • Remove the window regulator as a whole. It is important to remember your position. You can take a picture of it if it helps you fix the new window regulator. The window regulator is from time to time held in place by screws or rivets, it is therefore necessary to remove them.

The installation of an electric window regulator of a Hyundai Ix35

  • Position the new window regulator. Make sure that its position is identical to the damaged window regulator. You will probably have to use the fasteners that you removed.
  • Replace the glass in the same way as you removed it. It will be necessary from time to time to make it move slightly so that it fits correctly in its guide.
  • Reconnect the connectors.
  • Fit the seals that you have carefully removed.
  • Replace the entire door trim.

It's good, you now have a new and functional window regulator . You must therefore switch on the ignition and test it.