The advantage of an electric window regulator is substantial in comparison with manual systems. However, it has the disadvantage of being much more restrictive in terms of repairs. In addition, it is not necessarily easy to pinpoint the cause of the failure. With this article, we will see how to repair the electric window regulator of a hyundai matrix . But before you start, you have to be sure you understand where the malfunction is coming from. Indeed, it is from time to time unnecessary to replace the entire window regulator, a simple repair will sometimes work. Whether it concerns an electrical short circuit, or simply a lack of lubrication. Now that you've identified the nature of the problem, let's get back to our topic.change-window-regulator-hyundai-matrix

How to replace a hyundai matrix window regulator

The replacement of a window regulator is relatively long. Depending on your experience in the field, count approximately three hours to make sure you don't get caught up in time. Whether on a hyundai matrix or on another vehicle, this operation is for experienced DIY enthusiasts. So let's see what to do, step by step. We advise you to take photos at different times to help you mount the new window regulator.

Removing a window regulator on a hyundai matrix

  • Remove all of the door trim. From the handle to the mirror cover. This should be done relatively carefully using a flat screwdriver. It will be necessary to ensure access to the window regulator at any point without being obstructed. This step is quite long to perform.
  • Disassemble the window regulator seals from your hyundai matrix. Again, it is crucial to do this carefully.
  • Now that you have accessed the window regulator, remove the connectors. You can then release the window lifter motor when it is blocked.
  • Remove all the fasteners that hold the glass, then take it out. It is from time to time more advisable to position the window halfway up to carry out this manipulation. Naturally, extreme care must be taken when moving the glass. It is best to put it on a rather thick sheet.
  • Disassemble the window regulator entirely. It is essential to memorize your location. You can take a picture of it if it helps you fix the new window regulator. The window regulator is occasionally held by screws or rivets, so you must remove them.

Installation of an electric window regulator for a hyundai matrix

  • Fit the new window regulator. Make sure that its location is similar to the previous window regulator. You should definitely use the fasteners you removed.
  • Replace the glass as you removed it. It will be necessary from time to time to make it move a little so that it fits properly in its guide.
  • Connect the connectors.
  • Replace the seals that you have carefully removed.
  • Refit all of the door trim.

It's good, you now have a new and functional window regulator . So you can put the ignition on and test it.