The advantage of an electric window regulator is undeniable compared to manual window regulators. However, it has the disadvantage of being much more complex in terms of repairs. Also, it is not necessarily easy to pinpoint the origin of the fault. In this article we will see how to repair the electric window regulator of a hyundai santa fe . But before seeing the procedure to be followed, it is necessary to be certain to know where the dysfunction comes from. Indeed, it is from time to time unnecessary to change the entire window regulator, a simple repair will sometimes work. Whether it's an electrical short circuit, or just a lack of oil. Now that you've identified the nature of the problem, let's get back to our topic.
Replacing a window regulator from hyundai santa fe: how to do it
Changing a window regulator is relatively tedious. Depending on your experience in the field, count approximately three hours to make sure you don't get caught in the weather. Whether it is for a Hyundai Santa Fe or another car, this manipulation is for experienced DIY enthusiasts. So let's look at how to do it, step by step. We advise you to take pictures at several stages to help you reassemble the new window regulator.
Removing a window regulator on a Hyundai Santa Fe
- Remove the entire door trim. From the mirror cover to the handle. This should be done relatively carefully using a flat screwdriver. You must ensure that you have access to the window regulator at all points without being embarrassed. This step is quite long to perform.
- Remove the window regulator seals from your hyundai santa fe. Again, it's important to be careful.
- Now that you have access to the window regulator, remove the connectors. You can then release the window lifter motor when it is blocked.
- Take out all the fixings that hold the glass, then take it out. It is occasionally preferable to place the window halfway up to carry out this operation. Of course we will have to be very careful when moving the glass. It is best to put it on a rather thick sheet.
- Remove the window regulator completely. It is important to remember its location. You can take a picture of it if it helps you fix the new window regulator. The window regulator is occasionally held by screws or rivets, so they must be removed.
The installation of an electric window regulator of a Hyundai Santa Fe
- Position the new window regulator. Make sure that its position is similar to the damaged window lifter. You will probably need to use the fixings you removed.
- Reposition the glass just as you removed it. It will be necessary from time to time to rotate it a little so that it fits properly in its guide.
- Connect the connectors.
- Fit the seals you removed.
- Refit the entire door trim.
It's done, you now have a new and working window regulator . So you can switch on and test it.