The advantage of an electric window regulator is enormous in comparison with manual mechanisms. However, it has the defect of being much more restrictive in terms of repairs. Also, it is not necessarily easy to pinpoint the nature of the fault. With this article, we will see how to replace the electric window regulator of a Hyundai Satellite . But before seeing the procedure to follow, you must be certain to understand where the failure came from. Let's be clear, it is sometimes unnecessary to change the entire window regulator, a simple small repair can often suffice. Whether it's a false contact, or just a lack of lubrication. Now that you've identified the nature of the problem, let's get to the heart of the matter.
How to replace a Hyundai Satellite window regulator
Replacing a window regulator is quite time consuming. Depending on your expertise on the subject, plan approximately three hours to make sure you have the time you need. Whether for a Hyundai Satellite or another vehicle, this operation is for experienced DIY enthusiasts. So let's see how to do it, step by step. We advise you to take pictures at several stages in order to help you reassemble the new window regulator.
Removing a window regulator on a Hyundai Satellite
- Remove the entire door trim. From the mirror cover to the handle. This should be done with enough caution using a flat screwdriver. It will be necessary to ensure that you have access to the window regulator at any point without being disturbed. This step is quite long to perform.
- Remove the window regulator seals from your Hyundai Satellite. Again, it is crucial to do this carefully.
- Now that you have access to the window regulator, disconnect the connectors. You will then have to remove the motor from the window regulator if it is ever stuck.
- Take out all the fasteners that hold the glass, then remove it. It is sometimes advisable to place the window halfway up to be able to carry out this operation. Obviously, you will have to be very careful when handling the glass. It is best to put it on a sufficiently thick sheet.
- Remove the window regulator completely. It is essential to remember your position well. You can take a picture of it if it helps you to install the new window regulator. The window regulator is sometimes held in place by screws or rivets, so you must remove them.
Installation of an electric window regulator from a Hyundai Satellite
- Position the new window regulator. Make sure that its location is identical to the previous window regulator. You will probably have to use the fasteners you have set aside.
- Replace the glass as you removed it. It will sometimes be necessary to rotate it slightly so that it fits correctly in its guide.
- Connect the connectors.
- Replace the seals you removed.
- Replace the door trim assembly.
It's done, you now have a new and working window regulator . You will have to put the ignition on and test it.