The advantage of an electric window regulator is enormous compared to manual mechanisms. On the other hand, it has the disadvantage of being much more complicated in terms of repairs. Also, it is not always easy to precisely determine the source of the failure. With this article we will see how to replace the electric window regulator on a Hyundai Scoupe . But before you start, you need to be sure you know where the problem is coming from. Indeed, it is sometimes unnecessary to change the entire window regulator, a simple repair will sometimes work. Whether it concerns an electrical short circuit, or simply a lack of lubrication. Now that you've identified the source of the concern, let's get to the heart of the matter.
How to replace a Hyundai Scoupe window regulator
Changing a window regulator is quite tedious. Depending on your expertise on the subject, plan approximately two o'clock to make sure you don't get caught up in the time. Whether on a Hyundai Scoupe or on another vehicle, this repair is for experienced DIY enthusiasts. So let's see how to do it, step by step. It is advisable to take a picture at different times to help you fit the new window regulator.
Removing a window regulator on a Hyundai Scoupe
- Remove the entire door trim. From mirror cover to handle. This should be done carefully enough using a flat screwdriver. You will have to make sure you can access the window regulator at all points without being disturbed. This manipulation is quite long to perform.
- Remove the window regulator seals from your Hyundai Scoupe. Again, it is essential to do it delicately.
- Now that you have accessed the window regulator, remove the connectors. You will then have to remove the motor from the window regulator when the window is blocked.
- Release all the fasteners that hold the glass, then take it out. It is sometimes better to position the window halfway up to carry out this operation. Of course we will have to be very careful when handling the glass. It is best to put it on a sufficiently thick sheet.
- Disassemble the window regulator completely. It is essential to retain your position. You can take a picture of it if it helps you attach the new window regulator. The window regulator is sometimes held by screws or rivets, they must therefore be removed.
Installing an electric window regulator on a Hyundai Scoupe
- Present the new window regulator. Make sure that its position is similar to the previous window regulator. You will probably have to use the fasteners you have set aside.
- Replace the glass as you removed it. It will sometimes be necessary to move it slightly so that it sits correctly in its guide.
- Connect the connectors.
- Replace the seals that you have carefully removed.
- Replace the entire door trim.
It's done, you now have a new and functional window regulator . You will therefore have to turn on your car and test it.