The advantage of an electric window regulator is substantial compared to manual mechanisms. On the other hand, it has the defect of being much more complicated in terms of repairs. Also, it is not always easy to determine precisely the nature of the problem. Here we will see how to repair the electric window regulator of a hyundai sonata . But before seeing the procedure to follow, you must be sure to understand where the dysfunction comes from. Indeed, it is sometimes unnecessary to change the entire window regulator, a simple small repair can sometimes work. Whether it's an electrical short, or just a lack of oil. Now that you are sure of the cause of the problem, let's get to the heart of the matter.
Replacing a window regulator for hyundai sonata: how to do it
Changing a window regulator is quite long. Depending on your experience in the field, count approximately three hours to make sure you have the time you need. Whether on a Hyundai Sonata or another car, this operation is for experienced DIY enthusiasts. So let's take a look at how to do it, step by step. It is advisable to take pictures at several stages to help you install the new window regulator.
Removing a window regulator on a Hyundai Sonata
- Remove all of the door trim. From the handle to the mirror cover. This should be done with enough caution using a flat screwdriver. It will be necessary to ensure access to the window regulator at any point without being obstructed. This step is the longest to perform.
- Remove the window regulator seals from your hyundai sonata. Again, it is crucial to do it carefully.
- Now that you have access to the window regulator, remove the connectors. You must then release the window lifter motor when it is stuck.
- Remove all of the fasteners that hold the glass, then release it. It is sometimes preferable to position the window halfway up to be able to carry out this manipulation. Naturally, you will have to be very careful when moving the glass. It is best to put it on a rather thick sheet.
- Remove the window regulator as a whole. It is essential to remember its location. You can take a picture of it if it helps you to install the new window regulator. The window regulator is sometimes held in place by screws or rivets, it will therefore be necessary to remove them.
The installation of an electric window regulator of a Hyundai Sonata
- Introduce the new window regulator. Make sure that its location is similar to the damaged window lifter. You will probably need to use the clips you removed.
- Reposition the glass in the same way as you removed it. Sometimes it will be necessary to move it slightly so that it fits correctly in its guide.
- Connect the connectors.
- Replace the seals you removed.
- Replace all of the door trim.
It's good, you now have a new and working window regulator . You must therefore turn on your car and test it.