The advantage of an electric window regulator is enormous compared to manual window regulators. Nevertheless, it has the defect of being much more complicated in terms of repairs. Also, it is not always easy to pinpoint the origin of the fault. With this article, we will see how to replace the electric window regulator of a hyundai ride . But before you start, you need to be sure you understand where the problem is coming from. Let's be clear, it is sometimes unnecessary to replace the entire window regulator, a simple small repair can sometimes work. Whether it concerns a false contact, or just a lack of lubrication. Now that you are sure of the cause of the malfunction, let's get back to our topic.
Replacing a window regulator from hyundai route: how to do it
Replacing a window regulator is quite tedious. Depending on your experience in the field, count about three hours to make sure you have the time you need. Whether it is for a Hyundai trip or on another vehicle, this manipulation is for experienced DIY enthusiasts. So let's see how to do it, step by step. It is advisable to take pictures at different times to help you reassemble the new window regulator.
Removing a window regulator on a Hyundai route
- Dismantle the entire door trim. From the mirror cover to the handle. This should be done with enough caution using a flat screwdriver. You must ensure that you have access to the window regulator at all points without being obstructed. This manipulation is quite long to perform.
- Disassemble the window regulator seals from your hyundai route. Again, it is essential to do it delicately.
- Now that you have access to the window regulator, disconnect the connectors. You will then have to disengage the motor from the window regulator in case it is stuck.
- Release all the fasteners that hold the glass, then take it out. It is sometimes better to place the window halfway up to carry out this manipulation. Of course we will have to be super careful when moving the glass. It is best to put it on a rather thick sheet.
- Disassemble the window regulator completely. It is essential to remember its location. You can take a picture of it if it helps you fix the new window regulator. The window regulator is sometimes held by screws or rivets, it is thus necessary to remove them.
The installation of an electric window regulator for a Hyundai Journey
- Fit the new window regulator. Make sure that its position is identical to the previous window regulator. You must certainly use the fasteners you have set aside.
- Replace the glass just as you removed it. It will sometimes be necessary to rotate it a little so that it fits properly in its guide.
- Reconnect the connectors.
- Replace the seals that you have carefully removed.
- Replace all of the door trim.
That's it, you now have a new and working window regulator . You will need to turn on your car and test it.