The advantage of an electric window regulator is substantial compared to manual window regulators. However, it has the disadvantage of being much more complicated in terms of repairs. In addition, it is not always easy to identify precisely the nature of the failure. Here we will see how to replace the electric window regulator of an Iveco Eurocargo . But before you start, you need to be sure you know where the malfunction is coming from. Let us be clear, it is from time to time unnecessary to replace the entire window regulator, a simple small repair will often work. Whether it concerns a false contact, or just a lack of lubrication. Now that you've identified the cause of the malfunction, let's go back to our topic.
Replacing an Iveco Eurocargo window regulator: how to do it
Changing a window regulator is quite long. Depending on your experience in the field, plan about three hours to make sure you have the time you need. Whether on an Iveco Eurocargo or on another car, this repair is for experienced DIY enthusiasts. So let's look at how to do it, step by step. We advise you to take pictures at several stages in order to help you reassemble the new window regulator.
Removing a window regulator on an Iveco Eurocargo
- Remove the entire door trim. From the mirror cover to the handle. This should be done very gently with a flat screwdriver. You must ensure that you have access to the window regulator at all points without being obstructed. This step is quite long to perform.
- Remove the window regulator seals from your Iveco Eurocargo. Again, it is wiser to do it carefully.
- Now that you have accessed the window regulator, disconnect the connectors. You must then remove the motor from the window regulator if it is ever blocked.
- Remove all the fasteners that hold the glass, then remove the glass. It is from time to time more advisable to position the window halfway up to be able to carry out this operation. Of course, extreme care must be taken when moving the glass. It is advisable to place it on a rather thick sheet.
- Remove the window regulator completely. It is wiser to memorize your location. You can take a picture of it if it helps you to install the new window regulator. The window regulator is occasionally held by screws or rivets, so they must be removed.
Installing an electric window regulator from an Iveco Eurocargo
- Fit the new window regulator. Make sure that its location is similar to the previous window regulator. You will certainly have to use the bindings you have set aside.
- Replace the glass as you removed it. It will be necessary from time to time to rotate it a little so that it fits properly in its guide.
- Reconnect the connectors.
- Fit the seals you removed.
- Replace the door trim assembly.
It's good, you now have a new and functional window regulator . So you have to switch on and test it.