The advantage of an electric window regulator is substantial compared to manual window regulators. However, it has the disadvantage of being much more complex in terms of repairs. Also, it is not always easy to determine precisely the origin of the failure. With this article, we will see how to change the electric window regulator of a Jeep Comanche . But before seeing the procedure to follow, you must be sure to know where the dysfunction comes from. Indeed, it is sometimes unnecessary to change the entire window regulator, a simple small repair will often work. Whether it's an electrical short, or just a lack of oil. Now that you've identified the cause of the malfunction, let's go back to our topic.
How to replace a Jeep Comanche window regulator
Replacing a window regulator is relatively tedious. Depending on your experience in the field, count about three hours to make sure you don't get caught in the weather. Whether for a Jeep Comanche or another vehicle, this repair is for experienced DIY enthusiasts. So let's see what to do, step by step. It is advisable to take pictures at several stages to help you install the new window regulator.
Removing a window regulator on a Jeep Comanche
- Remove the entire door trim. From the handle to the mirror cover. This should be done relatively carefully with a flat screwdriver. It will be necessary to ensure access to the window regulator at any point without being obstructed. This manipulation is quite long to perform.
- Disassemble the window regulator seals from your Jeep Comanche. Again, it is essential to do it delicately.
- Now that you have access to the window regulator, disconnect the connectors. You can then release the window lifter motor if it is blocked.
- Take out all the fasteners that hold the glass, then release it. It is sometimes better to position the window halfway up to be able to carry out this operation. Of course you will have to be very careful when handling the glass. It is advisable to put it on a rather thick sheet.
- Disassemble the window regulator entirely. It is essential to remember its location. You can take a picture of it if it helps you fix the new window regulator. The window regulator is sometimes held by screws or rivets, so they must be removed.
The installation of an electric window regulator of a Jeep Comanche
- Fit the new window regulator. Make sure that its position is similar to the damaged window lifter. You will probably have to use the clips you removed.
- Reposition the glass just as you took it out. It will sometimes be necessary to rotate it a little so that it fits properly in its guide.
- Connect the connectors.
- Fit the seals you removed.
- Reassemble the door trim assembly.
It's good, you now have a new and working window regulator . So you can turn on your car and test it.