The advantage of an electric window regulator is undeniable compared to manual systems. However, it has the disadvantage of being much more complicated in terms of repairs. Also, it is not necessarily easy to pinpoint the cause of the problem. With this article, we will see how to replace the electric window regulator of a Jeep Commander . But before seeing the procedure to follow, you must be sure to know where the dysfunction came from. Let's be clear, it's regularly unnecessary to replace the entire window regulator, a simple small repair will often suffice. Whether it concerns an electrical short circuit, or just a lack of lubrication. Now that you are sure of the source of the problem, let's get to the heart of the matter.change-window-regulator-Jeep-Commander

Replacing a Jeep Commander window regulator: how to do it

Changing a window regulator is quite long. Depending on your expertise on the subject, plan approximately two o'clock to make sure you don't get caught up in time. Whether it is on a Jeep Commander or on another vehicle, this manipulation is for experienced DIY enthusiasts. So let's see what to do, step by step. We advise you to take photos at different times to help you reassemble the new window regulator.

Removing a window regulator on a Jeep Commander

  • Remove the entire door trim. From the mirror cover to the handle. This should be done very gently using a flat screwdriver. You must ensure that you have access to the window regulator at all points without being disturbed. This manipulation is the longest to carry out.
  • Remove the window regulator seals from your Jeep Commander. Again, it is essential to take it delicately.
  • Now that you have accessed the window regulator, disconnect the connectors. You can then remove the motor from the window regulator when the window is stuck.
  • Remove all the fasteners that hold the glass, then take it out. It is regularly advised to place the window halfway up to be able to carry out this operation. Of course you will have to be very careful when handling the glass. It is advisable to put it on a rather thick sheet.
  • Remove the window regulator as a whole. It is essential to remember its location. You can take a picture of it if it helps you fix the new window regulator. The window regulator is regularly maintained by screws or rivets, you must therefore remove them.

Installation of an electric window regulator for a Jeep Commander

  • Position the new window regulator. Make sure that its location is identical to the damaged window regulator. You will probably need to use the fasteners you have set aside.
  • Replace the glass just as you took it out. It will regularly be necessary to rotate it a little so that it fits correctly in its guide.
  • Reconnect the connectors.
  • Fit the seals you removed.
  • Reassemble the door trim assembly.

That's it, you now have a new and functional window regulator . You can therefore switch on the ignition and test it.