The interest of an electric window regulator is significant compared to manual systems. However, it has the drawback of being much more restrictive in terms of repairs. Furthermore, it is not always easy to identify precisely the nature of the problem. With this article we will see how to repair the electric window of a jeep compass . But before seeing what to do next, you have to be sure you know where the problem comes from. Indeed, it is sometimes useless to change the entire window regulator, a simple repair will often work. Whether it concerns an electrical short circuit, or simply a lack of lubrication. Now that you're sure what's causing the problem, let's get back to our topic.
How to replace a jeep compass window regulator
Replacing a window regulator is relatively time-consuming. Depending on your expertise in the field, plan approximately two o'clock to make sure you don't get caught up in the time. Whether for a jeep compass or another car, this manipulation is for experienced DIY enthusiasts. So let's see how to do it, point by point. We recommend that you take pictures at different times to help you fit the new window regulator.
Removing a window regulator on a jeep compass
- Remove the entire door trim. From the handle to the retro cover. This manipulation must be done relatively carefully with a flat screwdriver. You must ensure that you can access the window regulator at all points without being obstructed. This step is quite long to complete.
- Remove the window regulator gaskets from your jeep compass. Again, it's wiser to go about it carefully.
- Now that you have accessed the window regulator, disconnect the connectors. You can then remove the motor from the window regulator when it is blocked.
- Remove all of the clips that hold the glass, then release the glass. It is sometimes advisable to position the window halfway up to be able to perform this manipulation. Of course you have to be very careful when handling the glass. It is best to place it on a rather thick sheet.
- Remove the window regulator completely. It is wiser to retain your position well. You can take a picture of it if it helps you attach the new window regulator. The window regulator is sometimes held by screws or rivets, it will therefore be necessary to remove them.
The installation of an electric window of a jeep compass
- Fit the new window regulator. Make sure that its location is similar to the damaged window regulator. You should probably use the fasteners you have set aside.
- Replace the glass just as you removed it. It will sometimes be necessary to move it slightly so that it fits properly in its guide.
- Connect the connectors.
- Fit the seals you removed.
- Refit the entire door trim.
It's good, you now have a new and working window regulator . You can therefore turn on your car and test it.