The advantage of an electric window regulator is undeniable in comparison with manual mechanisms. However, it has the disadvantage of being much more restrictive in terms of repairs. Furthermore, it is not necessarily easy to determine precisely the nature of the problem. Here we will see how to change the electric window regulator of a jeep grand cherokee . But before you start, you need to be sure you know where the failure came from. Indeed, it is from time to time unnecessary to replace the entire window regulator, a simple repair can sometimes work. Whether it's a false contact, or simply a lack of lubrication. Now that you've identified the nature of the problem, let's get to the heart of the matter.change-window-lift-jeep-grand-cherokee

How to replace a grand cherokee jeep window regulator

Replacing a window regulator is rather time-consuming. Depending on your expertise in the field, plan approximately two o'clock to make sure you don't get caught up in time. Whether it's on a grand cherokee jeep or on another car, this operation is for experienced DIY enthusiasts. So let's look at what to do, step by step. We advise you to take photos at different times to help you install the new window regulator.

Removing a window regulator on a jeep grand cherokee

  • Remove the entire door trim. From the handle to the mirror cover. This should rather be done with caution using a flat screwdriver. You must ensure that you have access to the window regulator at all points without being disturbed. This manipulation is quite long to execute.
  • Remove the window regulator seals from your jeep grand cherokee. Again, it's important to be careful.
  • Now that you have access to the window regulator, remove the connectors. You can then release the window lifter motor in the event that the window is blocked.
  • Take out all the fasteners that hold the glass, then take it out. It is from time to time more wise to place the window halfway up to carry out this operation. Of course, great care must be taken when moving the glass. It is best to put it on a sufficiently thick sheet.
  • Remove the window regulator entirely. It is important to remember your position. You can take a picture of it if it helps you fix the new window regulator. The window regulator is occasionally held by screws or rivets, it will therefore be necessary to remove them.

The installation of an electric window regulator of a jeep grand cherokee

  • Introduce the new window regulator. Make sure that its position is similar to the previous window regulator. You will certainly have to use the clips you removed.
  • Replace the glass in the same way as you took it out. It will be necessary from time to time to rotate it slightly so that it fits properly in its guide.
  • Connect the connectors.
  • Replace the seals you removed.
  • Refit the entire door trim.

That's it, you now have a new and working window regulator . You can therefore switch on the ignition and test it.