The advantage of an electric window regulator is substantial compared to manual mechanisms. However, it has the disadvantage of being much more restrictive in terms of repairs. Also, it is not always easy to identify precisely the cause of the problem. In this article, we will discover how to change the electric window regulator of a Jeep Patriot . But before you start, you need to be sure you understand where the problem is coming from. Let's be clear, it is sometimes unnecessary to replace the entire window regulator, a simple repair can sometimes work. Whether it's an electrical short circuit, or just a lack of oil. Now that you've identified the source of the problem, let's get back to our topic.change-window-regulator-Jeep-Patriot

How to replace a Jeep Patriot window regulator

The replacement of a window regulator is quite long. Depending on your experience on the subject, count about three hours to make sure you have the time you need. Whether on a Jeep Patriot or another car, this operation is for experienced DIY enthusiasts. So let's look at how to do it, step by step. It is advisable to take photos at several stages in order to help you reassemble the new window regulator.

Removing a window regulator on a Jeep Patriot

  • Dismantle the entire door trim. From the mirror cover to the handle. This should be done very gently with a flat screwdriver. You must ensure that you have access to the window regulator at all points without being obstructed. This step is quite long to perform.
  • Disassemble the window regulator seals from your Jeep Patriot. Again, it is essential to do this carefully.
  • Now that you have access to the window regulator, remove the connectors. You must then release the motor from the window regulator when it is blocked.
  • Take out all the fasteners that hold the glass, then remove it. It is sometimes advisable to place the glass halfway up to be able to carry out this manipulation. Of course you will have to be extremely careful when handling the glass. It is advisable to place it on a rather thick sheet.
  • Disassemble the window regulator as a whole. It is essential to memorize your position. You can take a picture of it if it helps you to install the new window regulator. The window regulator is sometimes held in place by screws or rivets, it is therefore necessary to remove them.

The installation of an electric window regulator of a Jeep Patriot

  • Fit the new window regulator. Make sure that its position is similar to the damaged window lifter. You should probably use the fasteners you removed.
  • Reposition the glass just as you removed it. It will sometimes be necessary to move it a little so that it fits correctly in its guide.
  • Connect the connectors.
  • Fit the seals you removed.
  • Replace all of the door trim.

It's done, you now have a new and functional window regulator . You must therefore turn on your car and test it.