The advantage of an electric window regulator is substantial compared to manual systems. However, it has the drawback of being much more complex in terms of repairs. Also, it is not necessarily easy to identify precisely the cause of the failure. In this article we will find out How to replace the electric window regulator on a Jeep Renegade . But before you can see what to do next, you need to be sure you know where the problem is coming from. Indeed, it is sometimes useless to change the entire window regulator, a simple small repair can sometimes be sufficient. Whether it's a false contact, or just a lack of oiling. Now that you're sure where the concern is, let's get back to our topic.change-window-Jeep-Renegade

Jeep Renegade Window Regulator Replacement: How To

Replacing a window regulator is quite time consuming. Depending on your expertise in the field, count approximately two o'clock in order to be sure that you have the necessary time. Whether for a Jeep Renegade or on another vehicle, this operation is for experienced DIY enthusiasts. So let's look at what to do, point by point. We recommend that you take pictures in several steps to help you fit the new window regulator.

Removing a window regulator on a Jeep Renegade

  • Remove the entire door trim. From the handle to the retro cover. This manipulation should be done quite delicately using a flat screwdriver. You will have to make sure you have access to the window regulator at all points without being disturbed. This manipulation takes quite a long time to perform.
  • Remove the window regulator gaskets from your Jeep Renegade. Again, it is wiser to go about it with care.
  • Now that you have access to the window regulator, disconnect the connectors. You must then remove the motor from the window regulator if it is blocked.
  • Take out all the clips that hold the glass, then remove the glass. It is sometimes more advisable to position the window halfway up to be able to carry out this manipulation. Of course, we will have to be very careful when moving the window. It is best to place it on a rather thick sheet.
  • Remove the window regulator as a whole. It is wiser to hold on to your position. You can take a picture of it if it helps you attach the new window regulator. The window regulator is sometimes held by screws or rivets, so you have to remove them.

The installation of an electric window of a Jeep Renegade

  • Present the new window regulator. Make sure that its position is similar to the previous window regulator. You should probably use the fasteners you put aside.
  • Replace the glass just as you took it out. It will sometimes be necessary to rotate it a little so that it fits properly in its guide.
  • Connect the connectors.
  • Replace the seals you removed.
  • Reassemble the door trim assembly.

It's done, you now have a new and working window regulator . So you have to put the ignition on and test it.