The advantage of an electric window regulator is undeniable compared to manual window regulators. However, it has the disadvantage of being much more complex in terms of repairs. Also, it is not necessarily easy to pinpoint the cause of the problem. With this article we will see how to change the electric window regulator of a Jeep Willys . But before you start, you need to be sure you know where the malfunction is coming from. Indeed, it is sometimes unnecessary to change the entire window regulator, a simple small repair can sometimes work. Whether it concerns a false contact, or just a lack of oiling. Now that you are sure of the source of the concern, let us return to our subject.
Replacing a window regulator for Jeep Willys: how to do it
Replacing a window regulator is relatively tedious. Depending on your expertise in the field, count approximately three hours to make sure you don't get caught up in time. Whether for a Willys Jeep or another vehicle, this operation is for experienced DIY enthusiasts. So let's see how to do it, step by step. We advise you to take pictures at different times to help you reassemble the new window regulator.
Removing a window regulator on a Willys Jeep
- Remove all of the door trim. From the handle to the mirror cover. This should be done relatively carefully using a flat screwdriver. It will be necessary to ensure access to the window regulator at any point without being disturbed. This manipulation is the longest to perform.
- Remove the window regulator seals from your Jeep Willys. Again, it is wiser to take it delicately.
- Now that you have accessed the window regulator, remove the connectors. You will then have to disengage the window lifter motor if it is ever blocked.
- Remove all the fasteners that hold the glass, then remove the glass. It is sometimes better to place the window halfway up to carry out this manipulation. Of course, extreme care must be taken when moving the glass. It's best to put it on a rather thick sheet.
- Remove the window regulator entirely. It is wiser to remember its location. You can take a picture of it if it helps you fix the new window regulator. The window regulator is at times held by screws or rivets, you must therefore remove them.
The installation of an electric window regulator of a Jeep Willys
- Fit the new window regulator. Make sure that its position is similar to the damaged window lifter. You should probably use the fasteners you removed.
- Reposition the glass in the same way as you took it out. At times it will be necessary to move it a little so that it fits properly in its guide.
- Reconnect the connectors.
- Replace the seals you removed.
- Replace all of the door trim.
That's it, you now have a new and working window regulator . You will therefore have to switch on and test it.