The advantage of an electric window regulator is undeniable in comparison with manual systems. On the other hand, it has the defect of being much more complicated in terms of repairs. In addition, it is not necessarily easy to pinpoint the nature of the problem. With this article, we will discover how to change the electric window regulator of a Kia Pride Kombi . But before seeing the procedure to follow, you must be sure to understand where the dysfunction comes from. Let's be clear, it is regularly unnecessary to replace the entire window regulator, a simple repair can sometimes work. Whether it's an electrical short circuit, or just a lack of oil. Now that you've identified the root of the problem, let's get to the heart of the matter.
How to replace a Kia Pride Kombi window regulator
Changing a window regulator is rather time-consuming. Depending on your expertise in the field, count approximately three hours to make sure you have the time you need. Whether on a Kia Pride Kombi or on another car, this manipulation is for experienced DIY enthusiasts. So let's take a look at how to do it, step by step. We advise you to take pictures at different times to help you reassemble the new window regulator.
Removing a window regulator on a Kia Pride Kombi
- Remove all of the door trim. From the mirror cover to the handle. This should rather be done with care with a flat screwdriver. It will be necessary to ensure access to the window regulator at any point without being disturbed. This manipulation is quite long to execute.
- Disassemble the window regulator seals from your Kia Pride Kombi. Again, it is wiser to do it carefully.
- Now that you have access to the window regulator, remove the connectors. You can then release the window lifter motor if it is stuck.
- Release all the fasteners that hold the window, then release the window. It is regularly advisable to position the window halfway up to be able to carry out this manipulation. Of course we will have to be very careful when handling the glass. It is best to put it on a sufficiently thick sheet.
- Disassemble the window regulator completely. It is wiser to remember its location. You can take a picture of it if it helps you to install the new window regulator. The window regulator is regularly held by screws or rivets, so you must remove them.
The installation of an electric window regulator of a Kia Pride Kombi
- Fit the new window regulator. Make sure that its position is similar to the damaged window lifter. You will probably need to use the fasteners that you removed.
- Replace the glass as you removed it. It will regularly be necessary to move it a little so that it fits correctly in its guide.
- Connect the connectors.
- Fit the seals you removed.
- Replace all of the door trim.
That's it, you now have a new and functional window regulator . So you can switch on and test it.