The advantage of an electric window regulator is enormous compared to manual window regulators. However, it has the disadvantage of being much more restrictive in terms of repairs. Also, it's not always easy to pinpoint the cause of the problem. With this article, we will discover how to change the electric window regulator of a Kia Pro Cee D 2 . But before you start, you need to be sure you know where the failure came from. Indeed, it is from time to time unnecessary to replace the entire window regulator, a simple small repair can often suffice. Whether it's a false contact, or just a lack of oiling. Now that you've identified the cause of the malfunction, let's get to the heart of the matter.change-window-regulator-Kia-Pro-Cee-D-2

How to replace a Kia Pro Cee D 2 window regulator

Replacing a window regulator is rather tedious. Depending on your experience in the field, plan approximately two o'clock to make sure you don't get caught up in time. Whether on a Kia Pro Cee D 2 or another car, this repair is for experienced DIY enthusiasts. So let's take a look at how to do it, step by step. We advise you to take a photo at several stages in order to help you mount the new window regulator.

Removing a window regulator on a Kia Pro Cee D 2

  • Remove the entire door trim. From the handle to the mirror cover. This should rather be done with care using a flat screwdriver. You must ensure that you have access to the window regulator at all points without being obstructed. This manipulation is the longest to execute.
  • Disassemble the window regulator seals from your Kia Pro Cee D 2. Again, it's very important to do it gently.
  • Now that you have accessed the window regulator, disconnect the connectors. You will then have to remove the motor from the window regulator if it is stuck.
  • Remove all the fasteners that hold the glass, then remove the glass. It is from time to time more wise to place the window halfway up to carry out this manipulation. Of course you have to be very careful when handling the glass. It is advisable to place it on a sufficiently thick sheet.
  • Disassemble the window regulator completely. It is essential to remember its location. You can take a picture of it if it helps you to install the new window regulator. The window regulator is occasionally held by screws or rivets, so you must remove them.

Installing a Kia Pro Cee D 2 electric window regulator

  • Position the new window regulator. Make sure that its position is similar to the damaged window lifter. You will probably have to use the fasteners that you have set aside.
  • Reposition the glass in the same way as you removed it. It will be necessary from time to time to rotate it slightly so that it fits correctly in its guide.
  • Reconnect the connectors.
  • Fit the seals you removed.
  • Refit the entire door trim.

It's good, you now have a new and working window regulator . You will therefore have to switch on and test it.