The advantage of an electric window regulator is undeniable compared to manual mechanisms. However, it has the disadvantage of being much more complex in terms of repairs. Also, it is not always easy to pinpoint the nature of the failure. Here we will see how to replace the electric window regulator of a Kia Rio 4 . But before you start, you have to be sure you know where the problem came from. Let's be clear, it is sometimes unnecessary to replace the entire window regulator, a simple small repair will sometimes suffice. Whether it's a bad contact, or just a lack of lubrication. Now that you're sure where the problem is, let's get back to our topic.
How to replace a Kia Rio 4 window regulator
Replacing a window regulator is quite time consuming. Depending on your experience in the field, count approximately three hours to make sure you don't get caught up in the time. Whether it is for a Kia Rio 4 or another car, this repair is for experienced DIY enthusiasts. So let's look at what to do, step by step. We recommend that you take pictures at different times to help you fit the new window regulator.
Removing a window regulator on a Kia Rio 4
- Remove all of the door trim. From the handle to the retro cover. This manipulation should be done quite gently using a flat screwdriver. It will be necessary to make sure to have access to the window regulator at all points without being hampered. This step is quite long to perform.
- Remove the gaskets from the window regulator on your Kia Rio 4. Once again, it is important to do this carefully.
- Now that you have accessed the window regulator, disconnect the connectors. You must then remove the motor from the window regulator if it is blocked.
- Remove all the fasteners that hold the glass, then release the glass. It is sometimes more judicious to place the window halfway up to be able to perform this manipulation. Of course, you will have to be extremely careful when moving the window. It is preferable to place it on a rather thick sheet.
- Remove the window regulator as a whole. It is important to remember your position well. You can take a picture of it if it helps you attach the new window regulator. The window regulator is sometimes held by screws or rivets, so they must be removed.
Installing a Kia Rio 4 electric window regulator
- Position the new window regulator. Make sure that its location is similar to the damaged window regulator. You will probably have to use the bindings you have set aside.
- Reposition the glass as you removed it. It will sometimes be necessary to rotate it a little so that it fits correctly in its guide.
- Connect the connectors.
- Fit the seals you removed.
- Replace the entire door trim.
It's done, you now have a new and functional window regulator . So you need to turn on your car and test it.