The advantage of an electric window regulator is therefore compared to manual mechanisms. On the other hand, it has the defect of being much more complicated in terms of repairs. In addition, it is not always easy to identify precisely the source of the failure. With this article, we will discover how to replace the electric window regulator of a Kia Soul . But before you start, be sure you know where the problem came from. Let's be clear, it is sometimes unnecessary to change the entire window regulator, a simple small repair will sometimes suffice. Whether it's an electrical short, or just a lack of lubrication. Now that you've identified the nature of the problem, let's get back to our topic.change-window-lift-Kia-Soul

Replacing a Kia Soul window regulator: how to do it

Replacing a window regulator is rather tedious. Depending on your expertise in the field, count approximately three hours to make sure you don't get caught up in time. Whether for a Kia Soul or another car, this manipulation is for experienced DIY enthusiasts. So let's see what to do, step by step. We advise you to take pictures at different times to help you reassemble the new window regulator.

Removing a window regulator on a Kia Soul

  • Remove all of the door trim. From the handle to the mirror cover. This should rather be done with care using a flat screwdriver. It will be necessary to make sure to have access to the window regulator in any point without being obstructed. This step is quite long to perform.
  • Remove the window regulator seals from your Kia Soul. Again, it is wiser to take it delicately.
  • Now that you have accessed the window regulator, disconnect the connectors. You will then have to release the window lifter motor if it is stuck.
  • Take out all the fasteners that hold the glass, then remove it. It is sometimes more advisable to position the window halfway up to carry out this manipulation. Of course you will have to be very careful when handling the glass. It is advisable to place it on a rather thick sheet.
  • Remove the window regulator completely. It is wiser to memorize your position. You can take a picture of it if it helps you to install the new window regulator. The window regulator is sometimes held by screws or rivets, it will thus be necessary to remove them.

Installing a Kia Soul electric window regulator

  • Fit the new window regulator. Make sure that its position is similar to the previous window regulator. You will probably need to use the fasteners that you have set aside.
  • Replace the glass as you removed it. It will sometimes be necessary to move it a little so that it fits correctly in its guide.
  • Connect the connectors.
  • Fit the seals you removed.
  • Replace all of the door trim.

That's it, you now have a new and working window regulator . You will need to turn on your car and test it.