The advantage of an electric window regulator is substantial in comparison with manual window regulators. However, it has the disadvantage of being much more restrictive in terms of repairs. Also, it is not always easy to identify precisely the source of the failure. With this article, we will see how to repair the electric window regulator of a Mazda Sassou . But before seeing the procedure to follow, you must be certain to know where the failure came from. Let's be clear, it is sometimes unnecessary to replace the entire window regulator, a simple small repair will often work. Whether it concerns an electrical short circuit, or just a lack of oiling. Now that you've identified the source of the problem, let's get to the heart of the matter.
How to replace a window regulator in Mazda Sassou
Changing a window regulator is relatively tedious. Depending on your expertise in the field, plan approximately three hours to make sure you have the time you need. Whether it's on a Mazda Sassou or on another vehicle, this operation is for experienced DIY enthusiasts. So let's see what to do, step by step. We advise you to take pictures at several stages in order to help you mount the new window regulator.
Removing a window regulator on a Mazda Sassou
- Remove the entire door trim. From the mirror cover to the handle. This should be done relatively carefully with a flat screwdriver. It will be necessary to make sure to have access to the window regulator in any point without being obstructed. This step is the longest to perform.
- Remove the window regulator seals from your Mazda Sassou. Again, it is crucial to do it delicately.
- Now that you have access to the window regulator, disconnect the connectors. You will then have to remove the motor from the window regulator when it is blocked.
- Remove all the fasteners that hold the window, then remove the window. It is sometimes better to position the window halfway up to carry out this manipulation. Naturally we will have to be very careful when moving the glass. It is best to place it on a sufficiently thick sheet.
- Remove the window regulator completely. It is essential to remember its location. You can take a picture of it if it helps you fix the new window regulator. The window regulator is at times held by screws or rivets, you must therefore remove them.
The installation of an electric window regulator of a Mazda Sassou
- Fit the new window regulator. Make sure that its position is similar to the previous window regulator. You will certainly need to use the bindings you have set aside.
- Replace the glass just as you removed it. At times it will be necessary to rotate it slightly so that it fits correctly in its guide.
- Connect the connectors.
- Fit the seals that you have carefully removed.
- Refit the entire door trim.
It's good, you now have a new and working window regulator . You will therefore have to turn on your car and test it.