The advantage of an electric window regulator is enormous compared to manual systems. On the other hand, it has the drawback of being much more restrictive in terms of repairs. In addition, it is not necessarily easy to identify precisely the nature of the problem. With this article we will find out how to replace the electric window regulator of a Seat 600 . But before you start, you need to be sure you know where the problem is coming from. Let's be clear, it is sometimes unnecessary to replace the entire window regulator, a simple repair can sometimes work. Whether it's an electrical short circuit, or just a lack of oiling. Now that you've identified the cause of the problem, let's get back to our topic.window-changer-Seat-600

Replacing a window regulator in Seat 600: how to do it

Replacing a window regulator is relatively time consuming. Depending on your experience in the field, plan approximately three hours to make sure you don't get caught up in the time. Whether for a Seat 600 or on another car, this repair is for experienced DIY enthusiasts. So let's take a look at how to do it, step by step. It is advisable to take a picture at different times to help you fit the new window regulator.

Removing a window regulator on a Seat 600

  • Remove the entire door trim. From the handle to the retro cover. This manipulation must be done relatively carefully with a flat screwdriver. You will have to make sure you have access to the window regulator at all points without being disturbed. This step is quite long to perform.
  • Remove the window regulator gaskets from your Seat 600. Once again, it is wiser to go about it delicately.
  • Now that you have accessed the window regulator, disconnect the connectors. You must then release the motor from the window regulator if it is ever jammed.
  • Remove all the fasteners that hold the glass in place, then release the glass. It is sometimes more judicious to place the window halfway up to be able to carry out this manipulation. Of course, you will have to be very careful when moving the window. It is preferable to put it on a rather thick sheet.
  • Disassemble the window regulator as a whole. It is wiser to memorize its location well. You can take a picture of it if it helps you attach the new window regulator. The window regulator is sometimes held by screws or rivets, so they will have to be removed.

Installation of an electric window regulator for a Seat 600

  • Position the new window regulator. Make sure that its position is similar to the previous window regulator. You will probably need to use the fasteners you have set aside.
  • Replace the glass just as you removed it. It will sometimes be necessary to make it move a little so that it fits properly in its guide.
  • Connect the connectors.
  • Fit the seals that you have carefully removed.
  • Refit the entire door trim.

It's good, you now have a new and functional window regulator . So you have to turn on your car and test it.