The advantage of an electric window regulator is substantial in comparison with manual window regulators. However, it has the disadvantage of being much more restrictive in terms of repairs. Also, it is not necessarily easy to pinpoint the nature of the problem. Here we will see how to repair the electric window regulator of a seat cordoba . But before seeing the procedure to follow, you must be sure to understand where the failure comes from. Indeed, it is sometimes unnecessary to replace the entire window regulator, a simple repair can sometimes be enough. Whether it's an electrical short circuit, or just a lack of oil. Now that you are sure of the cause of the malfunction, let's get back to our topic.change-window-regulator-seat-cordoba

Replacing a seat cordoba window regulator: how to do it

Replacing a window regulator is quite tedious. Depending on your expertise in the field, count approximately three hours to make sure you don't get caught up in time. Whether on a seat cordoba or on another vehicle, this repair is for experienced DIY enthusiasts. So let's see how to do it, step by step. We advise you to take pictures at different times to help you mount the new window regulator.

Removing a window regulator on a seat cordoba

  • Remove the entire door trim. From the handle to the mirror cover. This should be done with enough caution with a flat screwdriver. It will be necessary to make sure to have access to the window regulator in any point without being obstructed. This manipulation is quite long to perform.
  • Remove the window regulator seals from your seat cordoba. Again, it is wiser to do it carefully.
  • Now that you have accessed the window regulator, remove the connectors. You will then have to disengage the motor from the window regulator in case it is stuck.
  • Remove all of the fasteners that hold the glass, then release it. It is sometimes better to position the window halfway up to be able to perform this operation. Obviously, extreme care must be taken when handling the glass. It is advisable to place it on a sufficiently thick sheet.
  • Remove the window regulator entirely. It is wiser to remember its location. You can take a picture of it if it helps you to install the new window regulator. The window regulator is at times held by screws or rivets, so it will be necessary to remove them.

Installation of an electric window regulator for a seat cordoba

  • Position the new window regulator. Make sure that its position is similar to the damaged window lifter. You will probably need to use the fasteners you have set aside.
  • Replace the glass just as you removed it. At times it will be necessary to move it a little so that it fits correctly in its guide.
  • Connect the connectors.
  • Fit the seals you removed.
  • Reassemble the door trim assembly.

It's done, you now have a new and functional window regulator . You will therefore have to switch on and test it.