The advantage of an electric window regulator is enormous compared to manual window regulators. However, it has the disadvantage of being much more complex in terms of repairs. Also, it is not necessarily easy to identify precisely the nature of the problem. In this article we will see how to replace the electric window regulator of a Seat Ginebra . But before you start, you need to be sure you know where the malfunction is coming from. Indeed, it is sometimes unnecessary to change the entire window regulator, a simple small repair can sometimes be enough. Whether it concerns a false contact, or just a lack of lubrication. Now that you've identified the cause of the problem, let's get back to our topic.change-window-lift-Seat-Ginebra

Replacing a Seat Ginebra window regulator: how to do it

Replacing a window regulator is quite tedious. Depending on your expertise on the subject, plan approximately three hours to make sure you don't get caught up in time. Whether on a Seat Ginebra or on another car, this operation is for experienced DIY enthusiasts. So let's see what to do, step by step. It is advisable to take pictures at different times to help you install the new window regulator.

Removing a window regulator on a Seat Ginebra

  • Remove the entire door trim. From the handle to the mirror cover. This should be done with enough caution using a flat screwdriver. You must ensure that you have access to the window regulator at all points without being disturbed. This manipulation is quite long to perform.
  • Disassemble the window regulator seals from your Seat Ginebra. Again, it is essential to do this carefully.
  • Now that you have accessed the window regulator, disconnect the connectors. You will then have to disengage the window lifter motor if it is ever blocked.
  • Release all of the fasteners that hold the window, then release it. It is sometimes more advisable to position the window halfway up to carry out this manipulation. Of course you have to be very careful when handling the glass. It is best to place it on a sufficiently thick sheet.
  • Disassemble the window regulator as a whole. It is essential to memorize your position. You can take a picture of it if it helps you fix the new window regulator. The window regulator is sometimes held in place by screws or rivets, so you will need to remove them.

Installation of an electric window regulator on a Seat Ginebra

  • Present the new window regulator. Make sure that its position is similar to the previous window regulator. You will certainly need to use the fasteners you have removed.
  • Replace the glass just as you pulled it out. Sometimes it will be necessary to move it slightly so that it fits properly in its guide.
  • Connect the connectors.
  • Replace the seals that you have carefully removed.
  • Replace the entire door trim.

That's it, you now have a new and working window regulator . You will have to put the ignition on and test it.