The advantage of an electric window regulator is enormous compared to manual mechanisms. However, it has the disadvantage of being much more complex in terms of repairs. Also, it is not necessarily easy to precisely determine the source of the failure. With this article, we will see how to change the electric window regulator of a Suzuki Baleno . But before you start, you have to be sure you understand where the breakdown comes from. Let us be clear, it is from time to time unnecessary to replace the entire window regulator, a simple repair can often suffice. Whether it concerns a false contact, or simply a lack of oiling. Now that you've identified the nature of the concern, let's get back to our topic.
Replacing a window regulator from Suzuki Baleno: how to do it
Replacing a window regulator is relatively time-consuming. Depending on your expertise on the subject, plan approximately two o'clock to make sure you have the time you need. Whether for a Suzuki Baleno or another car, this operation is for experienced DIY enthusiasts. So let's look at what to do, step by step. We advise you to take photos at different times to help you install the new window regulator.
Removing a window regulator on a Suzuki Baleno
- Dismantle the entire door trim. From the handle to the mirror cover. This should be done relatively carefully using a flat screwdriver. You must ensure that you access the window regulator at all points without being disturbed. This step is quite long to perform.
- Remove the window regulator seals from your Suzuki Baleno. Again, it is crucial to do it delicately.
- Now that you have accessed the window regulator, disconnect the connectors. You will then have to remove the motor from the window regulator when it is blocked.
- Take out all the fasteners that hold the glass, then take it out. It is from time to time preferable to position the window halfway up to perform this operation. Of course you have to be very careful when moving the window. It is advisable to place it on a sufficiently thick sheet.
- Remove the window regulator entirely. It is essential to memorize your position. You can take a picture of it if it helps you to install the new window regulator. The window regulator is from time to time held in place by screws or rivets, it will therefore be necessary to remove them.
The installation of an electric window regulator of a Suzuki Baleno
- Introduce the new window regulator. Make sure that its position is similar to the damaged window lifter. You will probably need to use the clips you removed.
- Replace the glass just as you pulled it out. It will occasionally be necessary to rotate it a little so that it fits properly in its guide.
- Connect the connectors.
- Replace the seals that you have carefully removed.
- Refit all of the door trim.
It's done, you now have a new and functional window regulator . You will therefore have to turn on your car and test it.