The advantage of an electric window regulator is enormous in comparison with manual mechanisms. However, it has the disadvantage of being much more complicated in terms of repairs. In addition, it is not necessarily easy to precisely determine the origin of the failure. With this article, we will discover how to replace the electric window regulator of a Suzuki Carry . But before you start, you need to be sure you understand where the malfunction is coming from. Indeed, it is sometimes unnecessary to change the entire window regulator, a simple repair will sometimes suffice. Whether it's a false contact, or just a lack of lubrication. Now that you are sure of the source of the problem, let us return to our subject.
Replacing a window regulator from Suzuki Carry: how to do it
Changing a window regulator is quite tedious. Depending on your experience in the field, plan approximately two o'clock to make sure you have the time you need. Whether it's for a Suzuki Carry or another car, this repair is for experienced DIY enthusiasts. So let's take a look at how to do it, step by step. We advise you to take photos at different times to help you install the new window regulator.
Removing a window regulator on a Suzuki Carry
- Dismantle the entire door trim. From the mirror cover to the handle. This should be done with enough caution using a flat screwdriver. You will have to make sure you have access to the window regulator at any point without being disturbed. This step is quite long to perform.
- Remove the window regulator seals from your Suzuki Carry. Again, it is essential to do it delicately.
- Now that you have accessed the window regulator, disconnect the connectors. You must then remove the motor from the window regulator if it is blocked.
- Remove all the clips that hold the glass, then remove the glass. It is sometimes preferable to position the window halfway up to perform this operation. Of course you have to be very careful when handling the glass. It is advisable to place it on a rather thick sheet.
- Remove the window regulator completely. It is essential to remember its location. You can take a picture of it if it helps you to install the new window regulator. The window regulator is sometimes held in place by screws or rivets, so you will need to remove them.
The installation of an electric window regulator of a Suzuki Carry
- Fit the new window regulator. Make sure that its position is identical to the previous window regulator. You will probably have to use the clips you removed.
- Replace the glass in the same way as you removed it. It will sometimes be necessary to move it slightly so that it fits properly in its guide.
- Reconnect the connectors.
- Fit the seals that you have carefully removed.
- Refit all of the door trim.
It's good, you now have a new and working window regulator . So you have to put the ignition on and test it.