The advantage of an electric window regulator is enormous in comparison with manual mechanisms. However, it has the disadvantage of being much more complicated in terms of repairs. In addition, it is not necessarily easy to identify precisely the source of the failure. With this article we will see how to repair the electric window regulator of a Suzuki Ignis . But before you see what to do, you need to be sure you know where the malfunction is coming from. Indeed, it is sometimes unnecessary to replace the entire window regulator, a simple repair will sometimes suffice. Whether it's an electrical short circuit, or simply a lack of lubrication. Now that you are sure of the source of the problem, let's get to the heart of the matter.
Replacing a window regulator from Suzuki Ignis: how to do it
Changing a window regulator is relatively tedious. Depending on your experience on the subject, plan about two o'clock to make sure you have the time you need. Whether for a Suzuki Ignis or another vehicle, this operation is for experienced DIY enthusiasts. So let's take a look at how to do it, step by step. It is advisable to take pictures at several stages in order to help you mount the new window regulator.
Removing a window regulator on a Suzuki Ignis
- Dismantle the entire door trim. From the handle to the mirror cover. This should be done relatively carefully with a flat screwdriver. You must ensure that you access the window regulator at any point without being disturbed. This step is quite long to perform.
- Remove the window regulator seals from your Suzuki Ignis. Again, it is crucial to do it carefully.
- Now that you have accessed the window regulator, disconnect the connectors. You must then release the window lifter motor if it is blocked.
- Remove all the fasteners that hold the glass, then take it out. It is sometimes better to position the window halfway up to be able to carry out this manipulation. Obviously you have to be very careful when handling the glass. It is advisable to put it on a sufficiently thick sheet.
- Remove the window regulator as a whole. It is essential to memorize your location. You can take a picture of it if it helps you to install the new window regulator. The window regulator is at times held by screws or rivets, so they must be removed.
The installation of an electric window regulator of a Suzuki Ignis
- Present the new window regulator. Make sure that its location is similar to the previous window regulator. You probably need to use the fasteners that you have set aside.
- Reposition the glass just as you removed it. At times it will be necessary to rotate it slightly so that it fits correctly in its guide.
- Connect the connectors.
- Fit the seals you removed.
- Replace all of the door trim.
It's done, you now have a new and functional window regulator . So you have to put the ignition on and test it.