The advantage of an electric window regulator is substantial in comparison with manual window regulators. However, it has the disadvantage of being much more complex in terms of repairs. Also, it is not necessarily easy to pinpoint the exact cause of the failure. With this article we will see How to repair the electric window of a Suzuki Jimny . But before seeing what to do next, you have to be sure you know where the problem came from. Indeed, it is sometimes unnecessary to change the entire window regulator, a simple small repair will sometimes work. Whether it's a bad contact, or just a lack of lubrication. Now that you are sure what the source of the problem is, let's get to the heart of the matter.
Suzuki Jimny window regulator replacement: how to do it
The replacement of a window regulator is rather long. Depending on your expertise in the field, plan approximately two o'clock to make sure you don't get caught up in the weather. Whether for a Suzuki Jimny or on another car, this repair is for experienced DIY enthusiasts. So let's see how to do it, point by point. It is advisable to take a picture at different times in order to help you reassemble the new window regulator.
Removing a window regulator on a Suzuki Jimny
- Remove all of the door trim. From the handle to the retro cover. This operation should be done rather gently using a flat screwdriver. It will be necessary to make sure to have access to the window regulator at all points without being hampered. This step is the longest to perform.
- Remove the window regulator seals from your Suzuki Jimny. Again, it's important to go about it with care.
- Now that you have access to the window regulator, remove the connectors. You will then have to release the window lifter motor when it is blocked.
- Release all the clips that hold the window in place, then remove the window. It is sometimes preferable to place the glass halfway up to perform this operation. Of course you will have to be very careful when handling the glass. It is better to put it on a rather thick sheet.
- Remove the window regulator as a whole. It is important to remember your position. You can take a picture of it if it helps you fit the new window regulator. The window regulator is sometimes held by screws or rivets, you must therefore remove them.
Installing an electric window regulator on a Suzuki Jimny
- Position the new window regulator. Make sure that its position is similar to the previous window lifter. You will probably have to use the fasteners that you removed.
- Replace the glass just as you removed it. Sometimes it will be necessary to move it slightly so that it fits properly in its guide.
- Connect the connectors.
- Fit the seals you removed.
- Replace all of the door trim.
It's good, you now have a new and functional window regulator . You will therefore have to turn on your car and test it.