The advantage of an electric window regulator is enormous compared to manual systems. On the other hand, it has the defect of being much more complicated in terms of repairs. Also, it is not necessarily easy to pinpoint the source of the failure. With this article we will see how to change the electric window regulator of a Suzuki Swift 3 . But before you start, you need to be sure you understand where the failure came from. Let's be clear, it is sometimes unnecessary to change the entire window regulator, a simple repair can sometimes be enough. Whether it concerns an electrical short circuit, or simply a lack of lubrication. Now that you've identified the source of the problem, let's get back to our topic.
Replacing a window regulator in Suzuki Swift 3: how to do it
Replacing a window regulator is rather time-consuming. Depending on your expertise in the field, count approximately three hours to make sure you don't get caught up in time. Whether it is on a Suzuki Swift 3 or on another vehicle, this manipulation is for experienced DIY enthusiasts. So let's take a look at how to do it step by step. It is advisable to take photos at several stages in order to help you mount the new window regulator.
Removing a window regulator on a Suzuki Swift 3
- Dismantle the entire door trim. From the handle to the mirror cover. This should be done very gently using a flat screwdriver. You must ensure that you access the window regulator at any point without being disturbed. This manipulation is the longest to perform.
- Disassemble the window regulator seals from your Suzuki Swift 3. Again, it is essential to do this gently.
- Now that you have access to the window regulator, remove the connectors. You must then remove the motor from the window regulator if it is blocked.
- Release all the fasteners that hold the window, then take it out. It is sometimes better to position the window halfway up to carry out this operation. Obviously, you will have to be very careful when moving the glass. It is advisable to place it on a rather thick sheet.
- Disassemble the window regulator entirely. It is essential to memorize your location. You can take a picture of it if it helps you to install the new window regulator. The window regulator is at times held by screws or rivets, you must therefore remove them.
The installation of an electric window regulator of a Suzuki Swift 3
- Fit the new window regulator. Make sure that its location is similar to the damaged window regulator. You will probably have to use the fixings that you removed.
- Replace the glass in the same way as you removed it. At times it will be necessary to rotate it slightly so that it fits correctly in its guide.
- Connect the connectors.
- Fit the seals that you have carefully removed.
- Refit all of the door trim.
That's it, you now have a new and functional window regulator . You will therefore have to turn on your car and test it.