The advantage of an electric window regulator is substantial compared to manual window regulators. However, it has the disadvantage of being much more restrictive in terms of repairs. Also, it is not always easy to precisely identify the origin of the failure. In this article we will see how to replace the electric window regulator of a Suzuki Sx4 S-cross . But before you can see what to do next, you need to be sure you understand where the problem is coming from. Let's be clear, from time to time it is unnecessary to replace the entire window regulator, a simple small repair will often suffice. Whether it's a bad contact, or simply a lack of lubrication. Now that you've identified the source of the problem, let's get to the heart of the matter.change-window-regulator-Suzuki-Sx4-S-cross

Suzuki Sx4 S-cross window regulator replacement: how to do it

Replacing a window regulator is rather time-consuming. Depending on your experience in the field, plan approximately three hours in order to be sure to have the necessary time. Whether for a Suzuki Sx4 S-cross or on another car, this operation is for experienced handymen. So let's take a look at what to do, step by step. We recommend that you take a picture at different times to help you fit the new window regulator.

Removing a window regulator on a Suzuki Sx4 S-cross

  • Remove the entire door trim. From the handle to the retro cover. This operation should be done rather gently using a flat screwdriver. You must ensure that you can access the window regulator at all points without being disturbed. This manipulation takes quite a long time to perform.
  • Remove the window regulator seals from your Suzuki Sx4 S-cross. Again, it is essential to go about it with care.
  • Now that you have access to the window regulator, disconnect the connectors. You can then release the window lifter motor if it is blocked.
  • Take out all the clips that hold the glass in place, then remove the glass. It is from time to time more judicious to position the window halfway up to be able to carry out this operation. Of course you will have to be very careful when handling the glass. It is advisable to put it on a rather thick sheet.
  • Remove the window regulator completely. It is essential to remember your location. You can take a picture of it if it helps you fit the new window regulator. The window regulator is occasionally held by screws or rivets, you must therefore remove them.

The installation of an electric window of a Suzuki Sx4 S-cross

  • Fit the new window regulator. Make sure that its location is similar to the damaged window regulator. You will no doubt need to use the fasteners you have removed.
  • Replace the glass just as you took it out. From time to time it will be necessary to rotate it a little so that it fits correctly in its guide.
  • Reconnect the connectors.
  • Fit the seals that you have carefully removed.
  • Replace all of the door trim.

It's done, you now have a new and functional window regulator . You can therefore switch on the ignition and test it.