The advantage of an electric window regulator is considerable compared to manual systems. However, it has the disadvantage of being much more complex in terms of repairs. Also, it is not necessarily easy to pinpoint the source of the failure. Here we will see how to replace the electric window regulator of a Suzuki Sx4 . But before you start, you need to be sure you understand where the problem is coming from. Indeed, it is from time to time unnecessary to change the entire window regulator, a simple small repair will sometimes work. Whether it concerns an electrical short circuit, or simply a lack of lubrication. Now that you've identified the source of the problem, let's get back to our topic.change-window-regulator-Suzuki-Sx4

Replacing a window regulator in Suzuki Sx4: how to do it

Changing a window regulator is rather tedious. Depending on your experience on the subject, count approximately two o'clock to make sure you have the time you need. Whether it is on a Suzuki Sx4 or on another car, this operation is for experienced DIY enthusiasts. So let's see how to do it, step by step. We advise you to take pictures at different times to help you reassemble the new window regulator.

Removing a window regulator on a Suzuki Sx4

  • Remove all of the door trim. From the mirror cover to the handle. This should be done very gently using a flat screwdriver. You must ensure that you access the window regulator at any point without being disturbed. This manipulation is quite long to perform.
  • Disassemble the window regulator seals from your Suzuki Sx4. Again, it is wiser to do it carefully.
  • Now that you have accessed the window regulator, disconnect the connectors. You can then release the window lifter motor when it is stuck.
  • Release all the fasteners that hold the window, then remove the window. It is occasionally preferable to position the window halfway up to be able to carry out this operation. Of course you will have to be very careful when moving the glass. It is best to place it on a rather thick sheet.
  • Disassemble the window regulator as a whole. It is wiser to memorize your location. You can take a picture of it if it helps you fix the new window regulator. The window regulator is from time to time held in place by screws or rivets, it will therefore be necessary to remove them.

The installation of an electric window regulator of a Suzuki Sx4

  • Position the new window regulator. Make sure that its location is similar to the previous window regulator. You will probably have to use the fixings that you removed.
  • Reposition the glass in the same way as you took it out. It will be necessary from time to time to rotate it a little so that it fits correctly in its guide.
  • Reconnect the connectors.
  • Replace the seals you removed.
  • Refit all of the door trim.

That's it, you now have a new and functional window regulator . You can therefore switch on the ignition and test it.