The advantage of an electric window regulator is undeniable in comparison with manual systems. However, it has the disadvantage of being much more restrictive in terms of repairs. Also, it is not always easy to precisely determine the source of the failure. Here we will see how to replace the electric window on a Suzuki Wagon R + . But before you start, you need to be sure you understand where the problem is coming from. Indeed, it is sometimes unnecessary to replace the entire window regulator, a simple repair will often suffice. Whether it concerns an electrical short circuit, or only a lack of oiling. Now that you've identified the cause of the concern, let's get to the heart of the matter.
How to replace a Suzuki Wagon R + window regulator
The replacement of a window regulator is relatively long. Depending on your experience in the field, count approximately two o'clock to make sure you don't get caught up in the time. Whether on a Suzuki Wagon R + or on another vehicle, this repair is for experienced DIY enthusiasts. So let's see what to do, point by point. We recommend that you take a picture in several steps to help you fit the new window regulator.
Removing a window regulator on a Suzuki Wagon R +
- Remove the entire door trim. From mirror cover to handle. This operation must be done relatively carefully with a flat screwdriver. You must ensure that you have access to the window regulator at all points without being disturbed. This step is quite long to perform.
- Remove the window regulator seals from your Suzuki Wagon R +. Again, it's important to go about it with care.
- Now that you have accessed the window regulator, disconnect the connectors. You can then remove the motor from the window regulator when the window is stuck.
- Remove all the fasteners that hold the glass, then remove the glass. It is sometimes preferable to position the window halfway up to be able to perform this operation. Obviously you will have to be very careful when moving the window. It is advisable to place it on a sufficiently thick sheet.
- Remove the window regulator completely. It is important to remember its location. You can take a picture of it if it helps you fit the new window regulator. The window regulator is sometimes held by screws or rivets, so they must be removed.
Installing an electric window on a Suzuki Wagon R +
- Fit the new window regulator. Make sure that its position is similar to the damaged window regulator. You may need to use the bindings you put aside.
- Replace the glass just as you removed it. At times it will be necessary to rotate it a little so that it fits properly in its guide.
- Connect the connectors.
- Fit the seals you removed.
- Reassemble the door trim assembly.
It's good, you now have a new and functional window regulator . So you can turn on your car and test it.