The advantage of an electric window regulator is enormous compared to manual mechanisms. However, it has the drawback of being much more complex in terms of repairs. Also, it is not necessarily easy to precisely determine the source of the fault. In this article we will find out how to change the electric window of a Toyota 2000 Gt Mf 10 . But before you start, you need to be sure you understand where the problem is. Indeed, it is sometimes unnecessary to change the entire window regulator, a simple small repair will often work. Whether it's a bad contact, or just a lack of lubrication. Now that you're sure what the problem is, let's get back to our topic.change-window-regulator-Toyota-2000-Gt-Mf-10

Replacing a window regulator in Toyota 2000 Gt Mf 10: how to do it

Replacing a window regulator is relatively time-consuming. Depending on your experience on the subject, count about three hours in order to be sure not to be taken by the time. Whether on a Toyota 2000 Gt Mf 10 or on another car, this operation is for experienced DIY enthusiasts. So let's see what to do, step by step. We recommend that you take a photo in several steps to help you reassemble the new window regulator.

Removing a window regulator on a Toyota 2000 Gt Mf 10

  • Remove all of the door trim. From the handle to the retro cover. This manipulation should be done relatively gently using a flat screwdriver. You must ensure that you have access to the window regulator at all points without being disturbed. This step is the longest to perform.
  • Remove the window regulator gaskets from your Toyota 2000 Gt Mf 10. Once again, it's wiser to go about it with care.
  • Now that you have accessed the window regulator, disconnect the connectors. You can then release the window lifter motor if it is stuck.
  • Remove all the fasteners that hold the glass, then remove the glass. It is sometimes more advisable to place the window halfway up to perform this manipulation. Of course you will have to be very careful when handling the glass. It is preferable to put it on a sufficiently thick sheet.
  • Remove the window regulator as a whole. It is wiser to memorize its location well. You can take a picture of it if it helps you fit the new window regulator. The window regulator is sometimes held by screws or rivets, they must therefore be removed.

The installation of an electric window regulator of a Toyota 2000 Gt Mf 10

  • Fit the new window regulator. Make sure that its position is similar to the previous window regulator. You may need to use the fasteners you removed.
  • Replace the glass as you removed it. It will at times be necessary to make it move a little so that it fits correctly in its guide.
  • Connect the connectors.
  • Replace the seals you removed.
  • Replace all of the door trim.

It's good, you now have a new and working window regulator . You can therefore turn on your car and test it.