The interest of an electric window regulator is consequent in comparison with manual systems. However, it has the disadvantage of being much more complex in terms of repairs. In addition, it is not necessarily easy to determine precisely the cause of the failure. In this article we will see how to replace the electric window regulator of a Toyota Camry 3 . But before you start, you have to be sure you know where the problem is coming from. Indeed, it is regularly unnecessary to replace the entire window regulator, a simple repair will sometimes suffice. Whether it's an electrical short circuit, or just a lack of lubrication. Now that you've identified the nature of the problem, let's get to the heart of the matter.change-window-regulator-Toyota-Camry-3

Replacing a Toyota Camry 3 window regulator: how to do it

It takes a long time to change a window regulator. Depending on your experience on the subject, plan about two o'clock to make sure you don't get caught up in the time. Whether on a Toyota Camry 3 or on another car, this manipulation is for experienced DIY enthusiasts. So let's see how to do it, step by step. We advise you to take a picture at different times to help you reassemble the new window regulator.

Removing a window regulator on a Toyota Camry 3

  • Disassemble the entire door trim. From mirror cover to handle. This manipulation should be done rather delicately using a flat screwdriver. It will be necessary to make sure to access the window regulator at all points without being hampered. This manipulation is quite long to perform.
  • Remove the window regulator seals from your Toyota Camry 3. Once again, it is important to do this carefully.
  • Now that you have accessed the window regulator, disconnect the connectors. You can then release the window regulator motor in the event that it is blocked.
  • Release all the clips that hold the glass, then release the latter. It is regularly better to place the window halfway up to perform this manipulation. Of course, you will have to be very careful when handling the glass. It is best to place it on a sufficiently thick sheet.
  • Remove the window regulator entirely. It is important to remember its location. You can take a picture of it if it helps you fit the new window regulator. The window regulator is regularly held by screws or rivets, so they must be removed.

The installation of an electric window regulator of a Toyota Camry 3

  • Fit the new window regulator. Make sure that its position is similar to the previous window regulator. You will certainly need to use the fasteners you removed.
  • Replace the glass in the same way as you removed it. It will regularly be necessary to rotate it a little so that it fits properly in its guide.
  • Connect the connectors.
  • Replace the seals you removed.
  • Replace the entire door trim.

It's done, you now have a new and working window regulator . So you can put the ignition on and test it.