The advantage of an electric window regulator is undeniable in comparison with manual window regulators. However, it has the disadvantage of being much more complicated in terms of repairs. Also, it is not always easy to precisely determine the nature of the failure. Here we will find out how to replace the electric window regulator on a Toyota Corolla 6 . But before seeing what to do, you need to be sure you know where the failure came from. Indeed, it is from time to time unnecessary to replace the entire window regulator, a simple small repair will often suffice. Whether it's an electrical short circuit, or simply a lack of lubrication. Now that you're sure what's causing the problem, let's get to the heart of the matter.change-window-regulator-Toyota-Corolla-6

Toyota Corolla 6 window regulator replacement: how to do it

Replacing a window regulator is quite time consuming. Depending on your expertise on the subject, count approximately three hours to make sure you have the necessary time. Whether for a Toyota Corolla 6 or on another car, this manipulation is for experienced handymen. So let's see how to do it, point by point. We recommend that you take a picture in several steps to help you reassemble the new window regulator.

Removing a window regulator on a Toyota Corolla 6

  • Remove the entire door trim. From the handle to the retro cover. This manipulation should be done quite delicately using a flat screwdriver. You must ensure that you have unimpeded access to the window regulator at all points. This manipulation is the longest to perform.
  • Remove the window regulator seals from your Toyota Corolla 6. Once again, it is essential to do it with care.
  • Now that you have accessed the window regulator, remove the connectors. You can then release the window lifter motor if it is blocked.
  • Release all the fasteners that hold the glass, then release the latter. From time to time it is preferable to place the glass halfway up to perform this manipulation. Of course, great care must be taken when handling the glass. It is best to put it on a sufficiently thick sheet.
  • Remove the window regulator entirely. It is essential to memorize your position well. You can take a picture of it if it helps you fit the new window regulator. From time to time the window regulator is held in place by screws or rivets, so you have to remove them.

The installation of an electric window of a Toyota Corolla 6

  • Position the new window regulator. Make sure that its location is similar to the damaged window lifter. You will probably have to use the fasteners that you removed.
  • Replace the glass the same way you took it out. From time to time it will be necessary to rotate it a little so that it fits properly in its guide.
  • Connect the connectors.
  • Fit the seals that you have carefully removed.
  • Refit all of the door trim.

That's it, you now have a new and functional window regulator . So you can switch on and test it.