The advantage of an electric window regulator is enormous compared to manual mechanisms. However, it has the disadvantage of being much more complicated in terms of repairs. Also, it is not necessarily easy to pinpoint the source of the fault. In this article, we will see how to repair the electric window regulator of a Toyota Corona . But before you start, you have to be sure you know where the problem came from. Let's be clear, it is sometimes unnecessary to change the entire window regulator, a simple small repair will often work. Whether it concerns a false contact, or simply a lack of lubrication. Now that you've identified the cause of the concern, let's get back to our topic.
Replacing a Toyota Corona window regulator: how to do it
The replacement of a window regulator is quite long. Depending on your experience in the field, count approximately two o'clock to make sure you have the time you need. Whether for a Toyota Corona or another vehicle, this manipulation is for experienced DIY enthusiasts. So let's take a look at what to do, step by step. We advise you to take photos at different times to help you reassemble the new window regulator.
Removing a window regulator on a Toyota Corona
- Remove the entire door trim. From the mirror cover to the handle. This should be done very gently using a flat screwdriver. You must ensure that you have access to the window regulator at all points without being disturbed. This step is quite long to perform.
- Remove the window regulator seals from your Toyota Corona. Again, it's important to be careful.
- Now that you have accessed the window regulator, remove the connectors. You can then remove the motor from the window regulator if it is stuck.
- Take out all the fasteners that hold the glass, then release it. It is sometimes advisable to position the window halfway up to carry out this manipulation. Naturally it will be necessary to be extremely careful when moving the glass. It is best to put it on a sufficiently thick sheet.
- Remove the window regulator completely. It is important to remember its location. You can take a picture of it if it helps you fix the new window regulator. The window regulator is sometimes held by screws or rivets, you must therefore remove them.
The installation of an electric window regulator of a Toyota Corona
- Introduce the new window regulator. Make sure that its location is similar to the damaged window regulator. You will probably have to use the fixings that you removed.
- Replace the glass just as you removed it. It will sometimes be necessary to rotate it slightly so that it fits correctly in its guide.
- Reconnect the connectors.
- Replace the seals you removed.
- Replace the entire door trim.
It's done, you now have a new and working window regulator . You can therefore switch on the ignition and test it.