The advantage of an electric window regulator is undeniable compared to manual systems. On the other hand, it has the defect of being much more restrictive in terms of repairs. Also, it is not always easy to identify precisely the nature of the problem. With this article, we will see how to change the electric window regulator of a Toyota Cressida . But before you start, you have to be sure you understand where the problem is coming from. Indeed, it is sometimes unnecessary to change the entire window regulator, a simple repair can often work. Whether it's an electrical short circuit, or just a lack of lubrication. Now that you've identified the source of the concern, let's get to the heart of the matter.change-window-lift-Toyota-Cressida

Replacing a Toyota Cressida window regulator: how to do it

The replacement of a window regulator is rather long. Depending on your experience in the field, count approximately two o'clock to make sure you don't get caught up in time. Whether for a Toyota Cressida or another car, this manipulation is for experienced DIY enthusiasts. So let's take a look at how to do it, step by step. We advise you to take photos at several stages to help you reassemble the new window regulator.

Removing a window regulator on a Toyota Cressida

  • Remove all of the door trim. From the handle to the mirror cover. This should be done rather gently using a flat screwdriver. You must ensure that you access the window regulator at any point without being disturbed. This step is the longest to perform.
  • Remove the window regulator seals from your Toyota Cressida. Again, it is crucial to do it delicately.
  • Now that you have access to the window regulator, remove the connectors. You must then release the window lifter motor if it is ever blocked.
  • Release all the fasteners that hold the window, then release it. It is sometimes more judicious to position the window halfway up to be able to carry out this manipulation. Naturally we will have to be very careful when moving the glass. It is best to put it on a sufficiently thick sheet.
  • Remove the window regulator entirely. It is essential to memorize your position. You can take a picture of it if it helps you to install the new window regulator. The window regulator is sometimes held in place by screws or rivets, you must therefore remove them.

The installation of an electric window regulator of a Toyota Cressida

  • Fit the new window regulator. Make sure that its position is similar to the previous window regulator. You will certainly need to use the fasteners you have removed.
  • Replace the glass just as you removed it. Sometimes it will be necessary to move it slightly so that it fits correctly in its guide.
  • Connect the connectors.
  • Replace the seals you removed.
  • Replace all of the door trim.

That's it, you now have a new and functional window regulator . You must therefore switch on the ignition and test it.