The advantage of an electric window regulator is undeniable in comparison with manual systems. However, it has the defect of being much more restrictive in terms of repairs. Also, it is not necessarily easy to identify precisely the origin of the problem. Here we will see how to repair the electric window regulator of a Toyota Dyna . But before you see what to do, you need to be sure you understand where the problem is coming from. Let's be clear, it is sometimes unnecessary to replace the entire window regulator, a simple small repair can often work. Whether it concerns a false contact, or simply a lack of lubrication. Now that you've identified the cause of the problem, let's get to the heart of the matter.
Replacing a Toyota Dyna window regulator: how to do it
Changing a window regulator is quite tedious. Depending on your expertise in the field, count approximately three hours to make sure you have the time you need. Whether it is for a Toyota Dyna or on another vehicle, this operation is for experienced DIY enthusiasts. So let's see how to do it, step by step. We advise you to take photos at different times to help you reassemble the new window regulator.
Removing a window regulator on a Toyota Dyna
- Remove all of the door trim. From the mirror cover to the handle. This should be done with enough caution using a flat screwdriver. You must ensure that you have access to the window regulator at all points without being embarrassed. This manipulation is the longest to carry out.
- Remove the window regulator seals from your Toyota Dyna. Again, it's wiser to do it delicately.
- Now that you have access to the window regulator, disconnect the connectors. You must then remove the motor from the window regulator when it is stuck.
- Release all of the fasteners that hold the glass, then take it out. It is sometimes advisable to place the window halfway up to be able to carry out this manipulation. Obviously, you will have to be very careful when handling the glass. It is advisable to put it on a rather thick sheet.
- Remove the window regulator completely. It is wiser to memorize your location. You can take a picture of it if it helps you to install the new window regulator. The window regulator is sometimes held in place by screws or rivets, and must therefore be removed.
The installation of an electric window regulator of a Toyota Dyna
- Introduce the new window regulator. Make sure that its location is similar to the previous window regulator. You probably need to use the fasteners you have set aside.
- Replace the glass just as you removed it. It will sometimes be necessary to rotate it a little so that it fits properly in its guide.
- Connect the connectors.
- Replace the seals that you have carefully removed.
- Refit all of the door trim.
It's done, you now have a new and working window regulator . You must therefore turn on your car and test it.