The advantage of an electric window regulator is undeniable compared to manual window regulators. However, it has the disadvantage of being much more complicated in terms of repairs. In addition, it is not always easy to pinpoint the cause of the problem. Here we will see how to change the electric window regulator of a Toyota Fine-s . But before you see what to do, you need to be sure you understand where the problem is coming from. Let's be clear, it is sometimes unnecessary to change the entire window regulator, a simple small repair will often suffice. Whether it's a false contact, or simply a lack of lubrication. Now that you've identified the nature of the dysfunction, let's get back to our topic.
Replacing a Toyota Fine-s window regulator: how to do it
Replacing a window regulator is relatively time-consuming. Depending on your expertise on the subject, count approximately three hours to make sure you have the time you need. Whether on a Toyota Fine-s or on another vehicle, this operation is for experienced DIY enthusiasts. So let's see what to do, step by step. We advise you to take pictures at several stages to help you reassemble the new window regulator.
Removing a window regulator on a Toyota Fine-s
- Remove the entire door trim. From the handle to the mirror cover. This should be done relatively gently with a flat screwdriver. You must ensure that you access the window regulator at all points without being disturbed. This manipulation is the longest to carry out.
- Disassemble the window regulator seals from your Toyota Fine-s. Again, it's important to be careful.
- Now that you have access to the window regulator, disconnect the connectors. You must then release the window lifter motor if it is stuck.
- Release all of the fasteners that hold the window, then release it. It is sometimes wiser to place the window halfway up to be able to carry out this operation. Obviously you have to be very careful when moving the glass. It is advisable to place it on a rather thick sheet.
- Disassemble the window regulator entirely. It is important to remember its location. You can take a picture of it if it helps you to install the new window regulator. The window regulator is sometimes held by screws or rivets, it will thus be necessary to remove them.
The installation of an electric window regulator of a Toyota Fine-s
- Fit the new window regulator. Make sure that its position is similar to the previous window regulator. You probably need to use the fasteners that you have set aside.
- Reposition the glass in the same way as you took it out. Sometimes it will be necessary to rotate it slightly so that it fits properly in its guide.
- Connect the connectors.
- Fit the seals that you have carefully removed.
- Refit the entire door trim.
It's done, you now have a new and functional window regulator . So you have to turn on your car and test it.