The advantage of an electric window regulator is substantial in comparison with manual mechanisms. However, it has the disadvantage of being much more complex in terms of repairs. In addition, it is not necessarily easy to identify precisely the cause of the problem. In this article, we will discover how to repair the electric window regulator of a Toyota Fun Cruiser . But before you see what to do, you need to be sure you understand where the problem is coming from. Indeed, it is regularly useless to change the whole window regulator, a simple repair can sometimes work. Whether it concerns an electrical short circuit, or simply a lack of oiling. Now that you are sure of the cause of the malfunction, let's get back to our topic.window-changer-Toyota-Fun-Cruiser

Replacing a window regulator in Toyota Fun Cruiser: how to do it

Replacing a window regulator is rather time-consuming. Depending on your expertise on the subject, count approximately three hours to make sure you have the time you need. Whether on a Toyota Fun Cruiser or on another vehicle, this operation is for experienced DIY enthusiasts. So let's look at what to do, step by step. It is advisable to take photos at different times to help you install the new window regulator.

Removing a window regulator on a Toyota Fun Cruiser

  • Dismantle the entire door trim. From the handle to the mirror cover. This should be done rather gently using a flat screwdriver. You will have to make sure to access the window regulator at any point without being disturbed. This manipulation is quite long to perform.
  • Remove the window regulator seals from your Toyota Fun Cruiser. Again, it is essential to do this with care.
  • Now that you have access to the window regulator, disconnect the connectors. You will then have to remove the motor from the window regulator if it is blocked.
  • Take out all the fasteners that hold the glass, then release it. It is regularly preferable to place the window halfway up to be able to carry out this manipulation. Of course, extreme care must be taken when moving the glass. It is best to put it on a sufficiently thick sheet.
  • Remove the window regulator as a whole. It is essential to remember its location. You can take a picture of it if it helps you to install the new window regulator. The window regulator is regularly held by screws or rivets, it will therefore be necessary to remove them.

The installation of an electric window regulator of a Toyota Fun Cruiser

  • Fit the new window regulator. Make sure that its location is identical to the previous window regulator. You will probably need to use the fasteners you have set aside.
  • Replace the glass in the same way as you took it out. It will regularly be necessary to move it a little so that it fits correctly in its guide.
  • Reconnect the connectors.
  • Fit the seals that you have carefully removed.
  • Replace all of the door trim.

It's good, you now have a new and working window regulator . You will therefore have to turn on your car and test it.