The interest of an electric window regulator is enormous in comparison with manual mechanisms. However, it has the disadvantage of being much more complex in terms of repairs. Also, it is not necessarily easy to pinpoint the source of the failure. With this article we will see how to replace the electric window regulator on a Toyota Highlander . But before you can see what to do next, you need to be sure you know where the problem is coming from. Indeed, it is from time to time useless to change the entire window regulator, a simple repair can often work. Whether it concerns an electrical short circuit, or simply a lack of oiling. Now that you're sure where the problem is, let's get back to our topic.window-changer-Toyota-Highlander

Toyota Highlander window regulator replacement: how to do it

Changing a window regulator is rather tedious. Depending on your expertise in the field, plan approximately two o'clock to make sure you have the necessary time. Whether on a Toyota Highlander or on another vehicle, this manipulation is for experienced handymen. So let's look at what to do, point by point. We recommend that you take a picture at different times to help you fit the new window regulator.

Removing a window regulator on a Toyota Highlander

  • Remove all of the door trim. From the handle to the retro cover. This manipulation should be done rather carefully using a flat screwdriver. You will have to make sure you have access to the window regulator at all points without being disturbed. This manipulation is quite long to perform.
  • Remove the window regulator seals from your Toyota Highlander. Again, it's wiser to go about it carefully.
  • Now that you have accessed the window regulator, remove the connectors. You can then release the window lifter motor if it is stuck.
  • Take out all the fasteners that hold the glass in place, then remove the glass. From time to time, it is better to position the window halfway up to be able to carry out this manipulation. Of course, we will have to be very careful when moving the window. It is best to place it on a sufficiently thick sheet.
  • Remove the window regulator completely. It is wiser to memorize its location well. You can take a picture of it if it helps you attach the new window regulator. From time to time the window regulator is held in place by screws or rivets, so you have to remove them.

The installation of an electric window of a Toyota Highlander

  • Present the new window regulator. Make sure that its position is identical to the damaged window regulator. You will probably need to use the fasteners you put aside.
  • Replace the glass as you removed it. It will be necessary from time to time to make it move slightly so that it is properly placed in its guide.
  • Connect the connectors.
  • Fit the seals that you have carefully removed.
  • Refit all of the door trim.

It's good, you now have a new and working window regulator . You can therefore turn on your car and test it.