The advantage of an electric window regulator is enormous compared to manual systems. Nevertheless, it has the defect of being much more complicated in terms of repairs. Also, it's not always easy to pinpoint the cause of the problem. With this article, we will see how to replace the electric window regulator of a Toyota Land Cruiser Sw Serie 200 . But before seeing the procedure to follow, you must be certain to know where the failure came from. Indeed, it is sometimes unnecessary to change the entire window regulator, a simple repair can sometimes work. Whether it concerns an electrical short circuit, or simply a lack of oil. Now that you are sure of the nature of the malfunction, let's get back to our topic.window-changer-Toyota-Land-Cruiser-Sw-Serie-200

Replacing a window regulator in Toyota Land Cruiser Sw Serie 200: how to do it

Replacing a window regulator is relatively time-consuming. Depending on your expertise on the subject, plan around two o'clock to make sure you don't get caught up in time. Whether for a Toyota Land Cruiser Sw Serie 200 or another car, this manipulation is for experienced DIY enthusiasts. So let's take a look at what to do, step by step. It is advisable to take pictures at different times to help you reassemble the new window regulator.

Removing a window regulator on a Toyota Land Cruiser Sw Serie 200

  • Dismantle the entire door trim. From the handle to the mirror cover. This should be done relatively carefully using a flat screwdriver. You must ensure that you access the window regulator at all points without being disturbed. This manipulation is quite long to perform.
  • Remove the window regulator seals from your Toyota Land Cruiser Sw Serie 200. Again, this is essential to do so with care.
  • Now that you have accessed the window regulator, disconnect the connectors. You can then remove the motor from the window regulator if it is stuck.
  • Take out all the fasteners that hold the glass, then remove it. It is sometimes preferable to place the window halfway up to carry out this manipulation. Of course you have to be very careful when handling the glass. It is best to place it on a sufficiently thick sheet.
  • Remove the window regulator as a whole. It is essential to memorize your location. You can take a picture of it if it helps you to install the new window regulator. The window regulator is sometimes held in place by screws or rivets, you must therefore remove them.

The installation of an electric window regulator of a Toyota Land Cruiser Sw Serie 200

  • Present the new window regulator. Make sure that its position is similar to the previous window lifter. You probably need to use the fasteners you have set aside.
  • Reposition the glass in the same way as you removed it. Sometimes it will be necessary to move it slightly so that it fits correctly in its guide.
  • Reconnect the connectors.
  • Replace the seals that you have carefully removed.
  • Replace all of the door trim.

That's it, you now have a new and functional window regulator . You can therefore switch on the ignition and test it.