The interest of an electric window regulator is enormous in comparison with manual systems. On the other hand, it has the disadvantage of being much more complex in terms of repairs. Also, it is not necessarily easy to pinpoint the source of the failure. With this article we will see how to change the electric window on a Toyota Land Cruiser Sw Serie 80 . But before you start, be sure to understand where the failure is coming from. Let's be clear, it is sometimes unnecessary to change the entire window regulator, a simple small repair will sometimes suffice. Whether it concerns an electrical short circuit, or just a lack of lubrication. Now that you're sure where the concern is, let's get back to our topic.window-changer-Toyota-Land-Cruiser-Sw-Serie-80

Replacing a window regulator in Toyota Land Cruiser Sw Serie 80: how to do it

Changing a window regulator is quite long. Depending on your expertise on the subject, plan approximately two o'clock in order to be sure that you have the necessary time. Whether on a Toyota Land Cruiser Sw Serie 80 or on another vehicle, this manipulation is for experienced DIY enthusiasts. So let's take a look at how to do it, step by step. We recommend that you take pictures at different times to help you reassemble the new window regulator.

Removing a window regulator on a Toyota Land Cruiser Sw Serie 80

  • Remove the entire door trim. From the handle to the retro cover. This manipulation must be done quite delicately with a flat screwdriver. You will have to make sure you can access the window regulator at all points without being disturbed. This step is the longest to perform.
  • Remove the window regulator gaskets from your Toyota Land Cruiser Sw Serie 80. Once again, it is essential to do it delicately.
  • Now that you have accessed the window regulator, disconnect the connectors. You will then have to remove the motor from the window regulator if it is blocked.
  • Take out all the clips that hold the glass, then take out the glass. It is sometimes advisable to place the window halfway up to be able to perform this manipulation. Of course you will have to be very careful when handling the glass. It is advisable to put it on a rather thick sheet.
  • Disassemble the window regulator as a whole. It is essential to retain your position. You can take a picture of it if it helps you attach the new window regulator. The window regulator is sometimes held by screws or rivets, so you have to remove them.

The installation of an electric window regulator of a Toyota Land Cruiser Sw Serie 80

  • Present the new window regulator. Make sure that its position is similar to the previous window regulator. You should certainly use the fasteners that you have set aside.
  • Reposition the glass in the same way as you removed it. At times it will be necessary to move it a little so that it fits correctly in its guide.
  • Connect the connectors.
  • Fit the seals you removed.
  • Replace the door trim assembly.

It's done, you now have a new and functional window regulator . You will have to put the ignition on and test it.