The advantage of an electric window regulator is huge compared to manual window regulators. However, it has the disadvantage of being much more complex in terms of repairs. Also, it is not necessarily easy to precisely identify the source of the problem. In this article we will see how to change the electric window of a Toyota Mr 2 . But before you can see what to do, you need to be sure you understand where the failure is coming from. Indeed, it is sometimes unnecessary to change the entire window regulator, a simple repair can sometimes work. Whether it's a false contact, or simply a lack of oiling. Now that you've identified the source of the concern, let's get back to our topic.
Replacing a Toyota Mr 2 window regulator: how to do it
Replacing a window regulator is quite tedious. Depending on your expertise in the field, count approximately two o'clock in order to be sure that you have the necessary time. Whether for a Toyota Mr 2 or on another car, this operation is for experienced handymen. So let's look at what to do, point by point. It is advisable to take pictures at different times in order to help you fit the new window regulator.
Removing a window regulator on a Toyota Mr 2
- Remove the entire door trim. From mirror cover to handle. This operation should be done fairly delicately with a flat screwdriver. You will have to make sure you can access the window regulator at all points without being hampered. This step is quite long to perform.
- Remove the window regulator seals from your Toyota Mr 2. Once again, it is wiser to go about it with care.
- Now that you have access to the window regulator, disconnect the connectors. You will then have to disengage the window lifter motor if it is stuck.
- Release all the fasteners that hold the glass, then remove the glass. It is sometimes advisable to place the window halfway up to be able to carry out this operation. Of course, great care must be taken when handling the glass. It is preferable to place it on a sufficiently thick sheet.
- Remove the window regulator completely. It is wiser to memorize your position well. You can take a picture of it if it helps you attach the new window regulator. The window regulator is sometimes held by screws or rivets, so you have to remove them.
The installation of an electric window regulator of a Toyota Mr 2
- Fit the new window regulator. Make sure that its location is similar to the damaged window regulator. You will most likely need to use the fasteners you removed.
- Replace the glass in the same way you removed it. It will sometimes be necessary to rotate it slightly so that it fits properly in its guide.
- Connect the connectors.
- Fit the seals you removed.
- Reassemble the door trim assembly.
It's good, you now have a new and working window regulator . You will therefore have to switch on and test it.