The advantage of an electric window regulator is enormous in comparison with manual window regulators. However, it has the disadvantage of being much more restrictive in terms of repairs. Also, it is not necessarily easy to pinpoint the cause of the problem. In this article we will see how to repair the electric window regulator of a Toyota Pod . But before you start, you need to be sure you know where the problem is coming from. Indeed, it is regularly unnecessary to replace the entire window regulator, a simple repair will sometimes work. Whether it's an electrical short, or just a lack of lubrication. Now that you've identified the source of the problem, let's get back to our topic.change-window-lift-Toyota-Pod

Replacing a Toyota Pod window regulator: how to do it

Changing a window regulator is quite time consuming. Depending on your experience in the field, count approximately two o'clock to make sure you don't get caught up in time. Whether for a Toyota Pod or another car, this manipulation is for experienced DIY enthusiasts. So let's see how to do it, step by step. It is advisable to take pictures at several stages in order to help you reassemble the new window regulator.

Removing a window regulator on a Toyota Pod

  • Dismantle the entire door trim. From the handle to the mirror cover. This should be done very gently using a flat screwdriver. You must ensure that you have access to the window regulator at all points without being disturbed. This step is quite long to perform.
  • Remove the window regulator seals from your Toyota Pod. Again, it is important to take it delicately.
  • Now that you have accessed the window regulator, remove the connectors. You must then release the window lifter motor if it is blocked.
  • Remove all the fasteners that hold the glass, then take it out. It is regularly better to position the window halfway up to be able to carry out this operation. Of course, extreme care must be taken when moving the glass. It is advisable to put it on a sufficiently thick sheet.
  • Remove the window regulator entirely. It is important to remember its location. You can take a picture of it if it helps you to install the new window regulator. The window regulator is regularly held in place by screws or rivets, so they must be removed.

The installation of an electric window regulator of a Toyota Pod

  • Present the new window regulator. Make sure that its location is identical to the previous window regulator. You will probably have to use the clips you removed.
  • Replace the glass in the same way as you removed it. It will regularly be necessary to rotate it a little so that it fits properly in its guide.
  • Reconnect the connectors.
  • Replace the seals you removed.
  • Replace all of the door trim.

That's it, you now have a new and functional window regulator . So you have to put the ignition on and test it.