The advantage of an electric window regulator is undeniable compared to manual mechanisms. On the other hand, it has the defect of being much more restrictive in terms of repairs. Also, it is not always easy to pinpoint the source of the problem. Here we will see how to repair the electric window regulator of a Toyota Prius 3 . But before seeing the procedure to follow, you must be certain to understand where the failure comes from. Let's be clear, it is sometimes unnecessary to change the entire window regulator, a simple small repair can sometimes work. Whether it concerns a false contact, or simply a lack of oil. Now that you are sure of the cause of the malfunction, let's get to the heart of the matter.
Replacing a Toyota Prius 3 window regulator: how to do it
Changing a window regulator is relatively tedious. Depending on your experience in the field, plan approximately two o'clock to make sure you don't get caught up in time. Whether it is on a Toyota Prius 3 or on another vehicle, this manipulation is for experienced DIY enthusiasts. So let's look at how to do it, step by step. We advise you to take photos at different times to help you reassemble the new window regulator.
Removing a window regulator on a Toyota Prius 3
- Remove all of the door trim. From the handle to the mirror cover. This should be done relatively carefully using a flat screwdriver. You must ensure that you have access to the window regulator at all points without being disturbed. This step is quite long to perform.
- Remove the window regulator seals from your Toyota Prius 3. Again, it's important to do so with care.
- Now that you have access to the window regulator, disconnect the connectors. You can then remove the motor from the window regulator if it is stuck.
- Release all the fasteners that hold the window, then release it. It is sometimes preferable to place the window halfway up to be able to carry out this manipulation. Of course you will have to be very careful when handling the glass. It is best to put it on a sufficiently thick sheet.
- Remove the window regulator completely. It is important to remember your position. You can take a picture of it if it helps you to install the new window regulator. The window regulator is sometimes held by screws or rivets, so you must remove them.
The installation of an electric window regulator of a Toyota Prius 3
- Position the new window regulator. Make sure that its position is similar to the previous window regulator. You will certainly have to use the fasteners that you have set aside.
- Reposition the glass in the same way as you removed it. It will sometimes be necessary to rotate it a little so that it fits correctly in its guide.
- Reconnect the connectors.
- Fit the seals that you have carefully removed.
- Replace all of the door trim.
That's it, you now have a new and functional window regulator . So you can put the ignition on and test it.