The advantage of an electric window regulator is undeniable in comparison with manual systems. Nevertheless, it has the defect of being much more complicated in terms of repairs. Also, it is not necessarily easy to determine precisely the origin of the failure. In this article, we will see how to replace the electric window regulator of a Toyota Rav 4 (2th Generation) . But before seeing the procedure to follow, you must be sure to know where the dysfunction came from. Indeed, it is sometimes unnecessary to change the entire window regulator, a simple small repair can often work. Whether it concerns an electrical short circuit, or simply a lack of oil. Now that you are sure of the nature of the problem, let's get to the heart of the matter.window-changer-Toyota-Rav-4- (2th-Generation)

Replacing a window regulator in Toyota Rav 4 (2th Generation): how to do it

Replacing a window regulator is quite time consuming. Depending on your expertise on the subject, plan approximately three hours to make sure you don't get caught up in time. Whether on a Toyota Rav 4 (2nd Generation) or on another vehicle, this operation is for experienced DIY enthusiasts. So let's see what to do, step by step. It is advisable to take pictures at several stages in order to help you reassemble the new window regulator.

Removing a window regulator on a Toyota Rav 4 (2th Generation)

  • Remove all of the door trim. From the handle to the mirror cover. This should be done with enough caution with a flat screwdriver. It will be necessary to ensure access to the window regulator at any point without being obstructed. This manipulation is quite long to perform.
  • Remove the window regulator seals from your Toyota Rav 4 (2nd Generation). Again, it is crucial to do it delicately.
  • Now that you have accessed the window regulator, remove the connectors. You must then release the motor from the window regulator in the event that it is stuck.
  • Remove all of the clips that hold the glass, then remove the glass. It is sometimes advisable to position the window halfway up to carry out this manipulation. Obviously, extreme care must be taken when handling the glass. It is advisable to put it on a sufficiently thick sheet.
  • Remove the window regulator entirely. It is essential to remember its location. You can take a picture of it if it helps you to install the new window regulator. The window regulator is sometimes held in place by screws or rivets, so they must be removed.

The installation of an electric window regulator of a Toyota Rav 4 (2th Generation)

  • Present the new window regulator. Make sure that its position is similar to the damaged window lifter. You will probably need to use the fasteners you have set aside.
  • Replace the glass in the same way as you took it out. It will sometimes be necessary to rotate it a little so that it fits correctly in its guide.
  • Reconnect the connectors.
  • Replace the seals you removed.
  • Refit all of the door trim.

That's it, you now have a new and working window regulator . So you have to turn on your car and test it.