The advantage of an electric window regulator is enormous compared to manual systems. However, it has the defect of being much more restrictive in terms of repairs. In addition, it is not necessarily easy to identify precisely the source of the problem. In this article, we will see how to repair the electric window regulator of a Toyota Rav 4 (3rd Generation) . But before you start, you need to be sure you know where the fault is coming from. Indeed, it is from time to time unnecessary to replace the entire window regulator, a simple repair will sometimes work. Whether it concerns an electrical short circuit, or just a lack of lubrication. Now that you are sure of the source of the malfunction, let's get back to our topic.
Replacing a window regulator in Toyota Rav 4 (3th Generation): how to do it
The replacement of a window regulator is rather long. Depending on your experience on the subject, plan about three hours to make sure you have the time you need. Whether it is for a Toyota Rav 4 (3rd Generation) or another car, this operation is for experienced DIY enthusiasts. So let's take a look at how to do it, step by step. It is advisable to take pictures at different times to help you mount the new window regulator.
Removing a window regulator on a Toyota Rav 4 (3th Generation)
- Dismantle the entire door trim. From the mirror cover to the handle. This should rather be done with care using a flat screwdriver. You must ensure that you have access to the window regulator at all points without being obstructed. This manipulation is quite long to execute.
- Remove the window regulator seals from your Toyota Rav 4 (3rd Generation). Again, it's important to do it delicately.
- Now that you have accessed the window regulator, remove the connectors. You can then remove the motor from the window regulator if it is ever blocked.
- Take out all the fasteners that hold the glass, then remove it. It is from time to time preferable to position the window halfway up to be able to carry out this manipulation. Obviously we will have to be very careful when moving the glass. It's best to put it on a rather thick sheet.
- Remove the window regulator entirely. It is important to remember your position. You can take a picture of it if it helps you to install the new window regulator. The window regulator is occasionally held in place by screws or rivets, so they must be removed.
The installation of an electric window regulator of a Toyota Rav 4 (3th Generation)
- Fit the new window regulator. Make sure that its location is similar to the damaged window lifter. You will certainly have to use the bindings you have set aside.
- Reposition the glass as you removed it. It will be necessary from time to time to make it move a little so that it fits properly in its guide.
- Connect the connectors.
- Fit the seals that you have carefully removed.
- Refit all of the door trim.
That's it, you now have a new and functional window regulator . So you can turn on your car and test it.